Nissan Murano: Vehicle loading information / Securing the load

Cargo area luggage hooks
There are luggage hooks located in the
cargo area as shown. The hooks can be
used to secure cargo with ropes or other
types of straps.
When securing items using luggage
hooks located on the side finisher do not
apply a load overmore than 6.5 lbs. (29 N)
to a single hook.
The luggage hooks that are located on
the floor should have loads less than
110 lbs. (490 N) to a single hook.
WARNING
- Properly secure all cargo with ropes or
straps to help prevent it from sliding
or shifting. Do not place cargo higher
than the seatbacks. In a sudden stop
or collision, unsecured cargo could
cause personal injury.
- The child restraint top tether strap
may be damaged by contact with
items in the cargo area. Secure any
items in the cargo area. Your child
could be seriously injured or killed in a
collision if the top tether strap is
damaged.
- Do not load your vehicle any heavier
than the GVWR or the maximum front
and rear GAWRs. If you do, parts of
your vehicle can break, tire damage
could occur, or it can change the way
your vehicle handles. This could result
in loss of control and cause personal
injury.
Do not exceed the load limit of your
vehicle shown as “The combined
weight of occupants and cargo” on
the Tire and Loading Information label.
Do not exceed the number of
occupants shown as “Seating Capacity”
on the Tire and Loading Information
label...
The GVW must not exceed GVWR
or GAWR as specified on the
F.M.V.S.S./C.M.V.S.S. certification
label.
Do not load the front and rear
axle to the GAWR...
Other information:
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC Detection Condition
B2614
BCM
(Body control module)
Diagnosis condition
Always
Signal (terminal)
Accessory relay-1 control
Threshold
The following states are compared, and they do not match for 1 second or more:
State of accessory relay-1 control judged by BCM
State of accessory relay-1 control signal
Diagnosis delay time
1 second or more...
System Description
SYSTEM DIAGRAM*: ECM determines the start signal status by the signals of engine speed and battery voltage.SYSTEM DESCRIPTIONThis system improves engine operation when the air conditioner is used.Under the following conditions, the air conditioner is turned OFF...
Categories

LATCH system lower anchor locations -
bench seat
Your vehicle is equipped with special anchor
points that are used with LATCH system
compatible child restraints. This system
may also be referred to as the ISOFIX
or ISOFIX compatible system. With this system,
you do not have to use a vehicle seat
belt to secure the child restraint unless the
combined weight of the child and child restraint
exceeds 65 lbs. (29.5 kg). If the combined
weight of the child and child restraint
is greater than 65 lbs. (29.5 kg), use the vehicle’s
seat belt (not the lower anchors) to
install the child restraint. Be sure to follow
the child restraint manufacturer’s instructions
for installation.
read more