Nissan Murano: Towing safety / Safety chains
Always use suitable safety chains between
your vehicle and the trailer. The safety
chains should be crossed and should be
attached to the hitch, not to the vehicle
bumper or axle. The safety chains can be
attached to the bumper if the hitch ball is
mounted to the bumper. Be sure to leave
enough slack in the chains to permit turning
corners.
Class I trailer hitch equipment (receiver, ball
mount and hitch ball) can be used to tow
trailers of a maximum weight of 2,000 lbs.
(907 kg).
Tire pressures
When towing a trailer, inflate the
vehicle tires to the recommended
cold tire pressure indicated
on the Tire and Loading Information
label...
CAUTION
When splicing into the vehicle electrical
system, a commercially available
power-type module/converter must be
used to provide power for all trailer
lighting...
Other information:
Exploded View
1.
Rear suspension arm bushing
2.
Rear suspension member
3.
Rear knuckle
4.
Ball joint seat
5.
Cotter pin
6.
Stabilizer connecting rod
7.
Rear suspension arm
Front
Removal and Installation
REMOVALRemove the rear wheel and tire using power tool...
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P2297
A/F SENSOR1 (B1)
(O2 Sensor Out of Range During Deceleration Bank 1 Sensor 1)
Diagnosis condition
Engine run and fuel shut off
Signal
—
Threshold
Air fuel ratio(A/F) sensor 1 bank 1 is out of normal range
Diagnosis delay time
—
POSSIBLE CAUSEAir fuel ratio(A/F) sensor 1 bank1FAIL-SAFENot applicableDTC CONFIRMATION PROCEDUREPRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test...