Nissan Murano: Engine / Starting System :: Precaution. Precautions

Nissan Murano (Z52) 2015-2024 Service Manual / Engine / Starting System :: Precaution. Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions.

Information necessary to service the system safely is included in the “SRS AIR BAG” and “SEAT BELT” sections of this Service Manual.

WARNING:

Always observe the following items for preventing accidental activation:

To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision that would result in air bag inflation, it is recommended that all maintenance and repair be performed by an authorized NISSAN/INFINITI dealer.

Improper repair, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see “SRS AIR BAG”.

Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

WARNING:

Always observe the following items for preventing accidental activation:

When working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with the ignition/power switch ON or engine running, never use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.

When using air or electric power tools or hammers, always switch the ignition/power switch OFF, disconnect the 12V battery or batteries, and wait at least 3 minutes before performing any service.

Exhaust System :: Removal and Installation. Exhaust System

Exploded View 1. Center exhaust tube 2. Front exhaust tube 3. Ring gasket 4. Front exhaust tube bracket 5. Gasket 6. Mounting rubber 7...

Starting System :: Preparation. Preparation

Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description 165-GR8-1200KIT (—) Midtronics Battery Charger and Tester Tests batteries, starting and charging systems and charges batteries...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Intelligent Key System All Functions Cannot Operate (all Keys)

Diagnosis Procedure Intelligent Key system all functions cannot operate (door lock and engine start).SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) Door lock operation (remote keyless entry) Door lock operation (request switch) or back door open operation (opener switch of back door panel) Engine started with ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) Engine started with ignition switch operation (registered Intelligent Key placed next to ignition switch) NG NG No start No start CONDITIONS OF VEHICLE (OPERATING CONDITIONS)“ENGINE START BY I-KEY” setting in “Work support” mode of “BCM(INTELLIGENT KEY)” is ON...

Nissan Murano (Z52) 2015-2024 Service Manual: Horn :: Removal and Installation. Horn

Exploded View 1. Horn (LOW) 2. Horn (HIGH) Removal and Installation REMOVALRemove the front grille. Refer to Removal and Installation. Disconnect the harness connectors from the horns (LOW, HIGH). NOTE: Note the wiring harness connectors location prior to removal...