Nissan Murano: Storage / Roof rack (if so equipped)

Do not apply any load directly to the roof
side rails. Cross bars must be installed before
applying load/cargo/luggage to the
roof of the vehicle. Genuine NISSAN accessory
cross bars are available through a
NISSAN dealer. It is recommended that you
visit a NISSANdealer for additional information.
The service load capacity for the roof side
rails is 165 lbs. (74 kg.), however do not exceed
the cross bars load capacity.
Be careful that your vehicle does not exceed
the Gross Vehicle Weight Rating
(GVWR) or its Gross Axle Weight Rating
(GAWR front and rear).
For additional information regarding GVWR
and GAWR, refer to:
- “Vehicle loading information” or the
“Dimensions and weights” table in the
“Technical and consumer information”
section of this manual.
- F.M.V.S.S. or C.M.V.S.S. certification label
(located on the driver’s door pillar) (if so
equipped)
WARNING
- Always install the cross bars onto the
roof side rails before loading cargo of
any kind. Loading cargo directly onto
the roof side rails or the vehicle’s roof
may cause vehicle damage.
- Drive extra carefully when the vehicle
is loaded at or near the cargo carrying
capacity, especially if the significant
portion of that load is carried on the
cross bars.
- Heavy loading of the cross bars has
the potential to affect the vehicle stability
and handling during sudden or
unusual handling maneuvers.
- Roof rack cross bars should be evenly
distributed.
- Do not exceed maximum roof rack
cross bars load capacity.
- Properly secure all cargo with ropes or
straps to help prevent it from sliding
or shifting. In a sudden stop or collision,
unsecured cargo could cause
personal LIC2386 injury.
When securing items using luggage hooks
located on the back of the seat or side
finisher do not apply a load over more than
6.5 lbs. (29 N) to a single hook...
Other information:
The Intelligent Key functions can only be
used when the Intelligent Key is within the
specified operating range fromthe request
switch .
When the Intelligent Key battery is discharged
or strong radio waves are present
near the operating location, the Intelligent
Key operating range becomes narrower,
and the Intelligent Key may not function
properly...
System Description
SYSTEM DIAGRAMDESCRIPTIONCombination MeterThe combination meter sounds the alarm buzzer installed in the combination meter when receiving the buzzer output signal transmitted from each unit.BCMBCM receives signals from various units and transmits a buzzer output signal to the combination meter via CAN communication if it judges that the warning buzzer should be activated...