Nissan Murano: Defogger :: Symptom Diagnosis / Rear Window Defogger Switch Does Not Light, but Rear Window Defogger Operates

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Controls / Defogger :: Symptom Diagnosis / Rear Window Defogger Switch Does Not Light, but Rear Window Defogger Operates

Diagnosis Procedure

CHECK A/C SWITCH ASSEMBLY (REAR WINDOW DEFOGGER SWITCH)

Check that A/C switch assembly (rear window defogger switch) is operating normally.

Is the inspection result normal?

YES>>

Check intermittent incident. Refer to Intermittent Incident.

NO>>

Check rear window defogger switch. Refer to Diagnosis Procedure.

Both Doors Mirror Defogger Dont Operate but Rear Window Defogger Operates

Diagnosis Procedure CHECK DOOR MIRROR DEFOGGER FUSE Check if the following fuse in fuse block (J/B) is blown: Component Fuse No. Capacity Fuse block (J/B) 22 10 A Is the inspection result normal? YES>> GO TO 2...

Defogger :: Removal and Installation

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: U0433-83 Dist Sen Can Circ 2

DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition U0433-83 ICC SENSOR CAN CIRC 2 [Distance sensor (ICC sensor) CAN circuit 2] Diagnosis condition When Ignition switch is ON. Signal (terminal) — Threshold ADAS control unit received invalid data from distance sensor (ICC sensor) via ITS communication Diagnosis delay time 1 second or less POSSIBLE CAUSEDistance sensor (ICC sensor)ADAS control unitFAIL-SAFEThe following systems are canceled: Intelligent Cruise Control (ICC) Automatic Emergency Braking (AEB) Automatic Emergency Braking (AEB) with pedestrian detection Intelligent Forward Collision Warning (I-FCW) DTC Confirmation Procedure CHECK DTC PRIORITY If DTC “U0433-83” is displayed with DTC “U1000–01”, first diagnose the DTC “U1000–01”...

Nissan Murano (Z52) 2015-2024 Service Manual: Throttle Valve Closed Position Learning

Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time the harness connector of electric throttle control actuator or ECM is disconnected or electric throttle control actuator is cleaned...