Nissan Murano: Instruments and controls / Rear window and outside mirror (if so equipped) defroster switch

Nissan Murano (Z52) 2015-2024 Owners Manual / Instruments and controls / Rear window and outside mirror (if so equipped) defroster switch

Nissan Murano. Rear window and outside mirror (if so equipped) defroster switch

To defrost the rear window glass and outside mirrors (if so equipped), place the ignition switch in the ON position and push the rear window defroster switch on. The rear window defroster indicator light on the switch comes on. Push the switch again to turn the defroster off.

The rear window defroster automatically turns off after approximately 15 minutes.

CAUTION

When cleaning the inner side of the rear window, be careful not to scratch or damage the rear window defroster.

NOTE:

The top and bottom fewrows of wires on the rear window are not part of the rear window defroster system. These wires make up the antenna for the audio system.

Rear switch operation

If the rear window wiper operation is interrupted by snow, etc., the wiper may stop moving to protect its motor. If this occurs, turn the wiper switch to OFF and remove the snow, etc...

Headlight and turn signal switch

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P0794 Intermediate Speed Sensor a

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0794 INTERMEDIATE SPEED SENSOR A (Intermediate Shaft Speed Sensor "A" Circuit Intermittent) Diagnosis condition TCM power supply voltage: More than 11 V Signal — Threshold Primary pulley speed: more than 11820 rpm Diagnosis delay time Maintained 2 seconds POSSIBLE CAUSE Harness or connector (Primary speed sensor circuit is open or shorted) Primary speed sensor TCM FAIL-SAFE Start is slow Acceleration is slow Lock-up is not performed Manual mode is not activated Confirmation Procedure DTC CONFIRMATION PROCEDURECAUTION: Always drive vehicle at a safe speed...

Nissan Murano (Z52) 2015-2024 Service Manual: U1044 Eng Comm Circuit

DTC Description DTC DETECTION LOGICA signal voltage of LIN communication between ECM and generator is excessively low or excessively high. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1044 ENG COMM CIRCUIT (Engine communication circuit) Diagnosis condition Ignition switch ON Signal (terminal) Signal voltage of LIN communication Threshold Signal voltage between ECM and generator is excessively low or excessively high Diagnosis delay time — POSSIBLE CAUSE Harness or connectors (LIN communication circuit is open or shorted...