Nissan Murano: Audio, Visual & Navigation System :: Rear View Monitor System / Preparation. Preparation

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Information & Multimedia / Audio, Visual & Navigation System :: Rear View Monitor System / Preparation. Preparation

Special Service Tools

The actual shape of the tools may differ from those illustrated here.

Tool number

(TechMate No.)

Tool name
  Description

 —

(J-46534)

Trim Tool Set

Removing trim components
Commercial Service Tools
Tool name Description
Power tool

Loosening nuts, screws and bolts

    Precaution. Precautions

    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...

    System Description

    ..

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Heater Core


    Exploded View 1. Heating and cooling unit assembly 2. Front foot duct (LH) 3. Heater core pipes cover 4. Heater core Front Removal and Installation REMOVALNOTE: When removing components such as hoses, lines/tubes, etc., cap or plug openings to prevent fluid from spilling...

    Nissan Murano (Z52) 2015-2024 Service Manual: P0966 Pressure Control Solenoid B


    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0966 PC SOLENOID B (Pressure Control Solenoid B Control Circuit Low) Diagnosis condition TCM power supply voltage: More than 11 V Signal — Threshold TCM judges that solenoid valve circuit is shorted to ground Diagnosis delay time Maintained for 1 second POSSIBLE CAUSE Harness or connector (Primary pressure solenoid valve circuit shorted to ground) Primary pressure solenoid valve FAIL-SAFE Selector shock is large Start is slow Acceleration is slow Lock-up is not performed DTC Confirmation Procedure PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test...

    Categories

    read more

     
    Copyright © 2026 www.nimurano.com