Nissan Murano: Body Repair :: Repair Information / Preparation

Repairing High Strength Steel

High Strength Steel (HSS) High strength steel is used for body panels in order to reduce vehicle weight.Accordingly, precautions in repairing automotive bodies made of high strength steel are described below: Tensile strength Major applicable parts 370 - 590 MPa Lower front and rear hoodledge Upper hoodledge Side dash Roof bow No...

Repairing Material

Foam Repair During factory body assembly, foam insulators are installed in certain body panels and locations around the Nissan Murano vehicle. Use the following procedure(s) to replace any factory-installed foam insulators...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: U1010 Control Unit(can)

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition U1010 CONTROL UNIT(CAN) [Control unit (CAN)] Diagnosis condition When ignition switch ON. Signal (terminal) — Threshold — Diagnosis delay time 2 seconds or more POSSIBLE CAUSEBCMFAIL-SAFE— DTC Diagnosis Procedure Replace BCM When DTC U1010 is detected, replace BCM...

Nissan Murano (Z52) 2015-2024 Service Manual: B2422 Back Door State

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition B2422–78 BACK DOOR STATE (Back door state) Diagnosis condition All times Signal (terminal) Encoder LH A signal, encoder LH B signal, encoder RH A signal, encoder RH B signal (automatic back door control module connector terminal: 19, 20, 21) Threshold When the automatic back door control module detect the encoder pulse signal LH does not according with the encoder pulse signal RH Diagnosis delay time – B2422–79 BACK DOOR STATE (Back door state) Diagnosis condition All times Signal (terminal) – Threshold When automatic back door position information is deleted from automatic back door control module memory Diagnosis delay time – POSSIBLE CAUSE Improper installation of back door assembly Calibration of automatic back door position information Back door mechanism Encoder Harness or connectors (encoder circuit is open or shorted) Automatic back door control module Battery terminal is disconnected and reconnected FAIL-SAFEInhibit automatic back door system auto open/close function DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...