Nissan Murano: Preparation / Repairing Material
During factory body assembly, foam insulators are installed in certain body panels and locations around the Nissan Murano vehicle. Use the following procedure(s) to replace any factory-installed foam insulators.
URETHANE FOAM APPLICATIONS
Use commercially available urethane foam for sealant (foam material) repair of material used on vehicle.
| <Urethane foam for foaming agent> | 3M™ Flexible Foam 08463 or equivalent |
Read instructions on product for fill procedures.
CAUTION:
To avoid the risk of minor personal injury or property damage:
Always install urethane foam after welded panels are installed and welding is complete.
Example of foaming agent filling operation procedure:
Fill procedures after installation of service part.Eliminate foam material remaining on vehicle side. Clean area after eliminating foam insulator and foam material. Install service part. Insert nozzle into hole near fill area and fill foam material or fill enough to close gap with the service part.
| 1. | Urethane foam | A. | Nozzle insert hole |  |
Front |
Fill procedures before installation of service part:Eliminate foam material remaining on Nissan Murano vehicle side. Clean area after eliminating foam insulator and foam material. Fill with enough foam material on the wheelhouse outer side to close the gap with the service part while avoiding the flange area.
| 1. | Urethane foam |
| A. | Fill while avoiding flange area |
|
Front |
NOTE:
Refer to the label on the urethane foam container for information on working times.
Preparation
..
Body Component Parts
Underbody componet, Engine compartment parts
: Both sided anti-corrosive precoated steel portions
: High strength steel (HSS) portions
: Both sided anti-corrosive steel and HSS portions
No...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: L Terminal Circuit (open)
Diagnosis Procedure CHECK "L" TERMINAL CONNECTION Ignition switch OFF. Check if "L" terminal is clean and tight. Is the inspection result normal? YES>> GO TO 2. NO>> Repair "L" terminal connection. Confirm repair by performing system test using 165-DSS-5000P...
Nissan Murano (Z52) 2015-2024 Service Manual: B2416 Touch Sen R Open
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition B2416–1B TOUCH SEN R OPEN (Touch sensor right open) Diagnosis condition All times Signal (terminal) Touch sensor RH signal (automatic back door control module connector terminal: 4) Threshold When one of the following conditions is satisfied Touch sensor RH circuit is open Disconnect touch sensor RH connector Diagnosis delay time – B2416–1E TOUCH SEN R OPEN (Touch sensor right open) Diagnosis condition All times Signal (terminal) Touch sensor RH signal (automatic back door control module connector terminal: 4) Threshold When one of the following conditions is satisfied Touch sensor RH circuit is open Disconnect touch sensor RH connector Diagnosis delay time – POSSIBLE CAUSE Improper installation of touch sensor Touch sensor RH Harness or connectors (touch sensor circuit is open) Automatic back door control module FAIL-SAFEInhibit automatic back door system auto open/close function DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Passenger compartment
- Fuel recommendation
- Settings
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
