Other information:
Inspection and Adjustment
INSPECTIONCheck brake pad wear thickness from an inspection hole (A) on cylinder body. Check using a scale if necessary. Wear thickness
: Refer to Rear Disc Brake.
ADJUSTMENTCAUTION:
Burnish contact surfaces between brake pads and disc rotor according to the following procedure after refinishing the disc rotor, replacing brake pads or if a soft pedal occurs at very low mileage...
Component Function Check
CHECK COMBINATION METER INPUT SIGNAL
CONSULT
Select “BUCKLE SW” in “Data Monitor” mode of “METER/M&A”.
Check that the function operates normally according to the following conditions:
Monitor item
Condition
Status
BUCKLE SW
When front seat belt LH is fastened
OFF
When front seat belt LH is unfastened
ON
Is the inspection result normal?
YES>>
Inspection End...