Nissan Murano: Symptom Diagnosis / Normal Operating Condition

Nissan Murano (Z52) 2015-2024 Service Manual / Electrical & Power Control / Body Control System :: Bcm / Symptom Diagnosis / Normal Operating Condition

Description

SHIPPING MODE

  • Shipping mode inhibits battery power consumption during transportation or storage of the Nissan Murano vehicle. Vehicle is set to shipping mode before being shipped from the factory.

  • When ignition switch OFF, BCM operates shipping mode.

  • BCM control function is limited in shipping mode. Remote keyless entry function does not operate in shipping mode.

  • For shipping mode cancel operation, refer to Work Procedure.

    NOTE:

    Do not cancel shipping mode during storage of the Nissan Murano vehicle. Shipping mode should not be canceled until just prior to customer delivery.

    Combination Switch System Symptoms

    Symptom Table Perform the data monitor of CONSULT to check for any malfunctioning item. Check the malfunction combinations. Malfunction item: × Malfunction combination Data monitor item FR WIPER HI FR WIPER LOW FR WASHER SW FR WIPER INT INT VOLUME RR WIPER ON RR WIPER INT RR WASHER SW TURN SIGNAL R TURN SIGNAL L TAIL LAMP SW HI BEAM SW HEAD LAMP SW 1 HEAD LAMP SW 2 PASSING SW AUTO LIGHT SW FR FOG SW A × × × × B × × × × C × × × × D × × × × E × × × F × × × G × × × × H × × × I × × × × J × × × × K All Items L If only one item is detected or the item is not applicable to the combinations A to K Identify the malfunctioning part from the agreed combination and repair or replace the part...

    Removal and Installation

    ..

    Other information:

    Nissan Murano (Z52) 2015-2024 Owners Manual: Tire rotation


    NISSAN recommends rotating the tires every 5,000 miles (8,000 km). For additional information on tire replacing procedures, refer to “Flat tire” in the “In case of emergency” section of this manual. As soon as possible, tighten the wheel nuts to the specified torque with a torque wrench...

    Nissan Murano (Z52) 2015-2024 Service Manual: Sonar Control Unit


    Removal and Installation CAUTION: Before replacing the Sonar Control Unit, perform “BEFORE REPLACEMENT” to save or print current Nissan Murano vehicle specification. Refer to Description. REMOVALRemove the glove box assembly and housing. Refer to Removal and Installation...

    Categories

    LATCH (Lower Anchors and Tethers for CHildren) system

    Nissan Murano. LATCH (Lower Anchors and Tethers for CHildren) system

    LATCH system lower anchor locations - bench seat

    Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.

    read more

     
    Copyright © 2026 www.nimurano.com