Nissan Murano: Interior Lighting System :: Removal and Installation / Luggage Room Lamp

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Controls / Interior Lighting System :: Removal and Installation / Luggage Room Lamp

Removal and Installation

REMOVAL

Release luggage room lamp (1) pawl using a suitable tool.

: Pawl

Disconnect the harness connector from the luggage room lamp and remove.

INSTALLATION

Installation is in the reverse order of removal.

Bulb or Lens Replacement

WARNING:

Do not touch glass surface of a bulb while it is lit or right after being turned OFF to prevent burns.

CAUTION:

Do not touch glass of bulb directly by hand. Keep grease and other oily substances away from bulb surface.

Do not leave bulb out of lamp reflector for a long time because dust, moisture, smoke, etc. may affect performance of lamp.

Release and insert pawl as indicated in exploded view or damage may occur.

Remove luggage room lamp. Refer to Removal and Installation.

Release luggage room lamp cover (1) pawls using a suitable tool and remove from luggage room lamp (2).

: Pawl

Push tab to release one bulb end, then grasp bulb and pull out second end from its socket to remove.

Install cargo lamp bulb to cargo lamp.

Install luggage room lamp. Refer to Removal and Installation.

Personal Lamp 2nd Row

Removal and Installation REMOVALRemove the headlining. Refer to Removal and Installation. Release pawls using a suitable tool and remove personal lamp 2nd row...

Mood Lamp

Removal and Installation FRONT CONSOLERemovalRemove center console upper side finisher. Refer to Exploded View. Remove mood lamp (front console) (1) screw (B)...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Cluster Lid D

Removal and Installation REMOVALRemove cluster lid C. Refer to Removal and Installation. Remove screws from cluster lid D. Refer to Exploded View. Release clips using a suitable tool and remove cluster lid D (1). : Metal clip INSTALLATIONInstallation is in the reverse order of removal...

Nissan Murano (Z52) 2015-2024 Service Manual: P0112 Iat Sensor

DTC Description DTC DETECTION LOGIC An excessively low voltage from the sensor is sent to ECM. An excessively high voltage from the sensor is sent to ECM. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0112 IAT SEN/CIRCUIT-B1 (Intake air temperature sensor 1 circuit low bank 1) Diagnosis condition Ignition switch ON Signal (terminal) Voltage signal transmitted from intake air temperature sensor to ECM Threshold An excessively low voltage from the sensor is sent to ECM Diagnosis delay time — P0113 IAT SEN/CIRCUIT-B1 (Intake air temperature sensor 1 circuit high bank 1) Diagnosis condition Ignition switch ON Signal (terminal) Voltage signal transmitted from intake air temperature sensor to ECM Threshold An excessively high voltage from the sensor is sent to ECM Diagnosis delay time — POSSIBLE CAUSEP0112 Harness and connectors (The sensor circuit is open or shorted...