Nissan Murano: Door Motor / Intake Door Motor
Removal and Installation
REMOVAL
Remove the glove box assembly. Refer to Removal and Installation.
Remove the intake door motor screws.
Disconnect the harness connector from the intake door motor and remove.
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation - (LH)
REMOVALRemove the center console side finisher (LH). Refer to Exploded View.
Remove the instrument lower panel LH. Refer to Removal and Installation...
Other information:
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen item
(Trouble diagnosis content) DTC detected condition
C1142
PRESS SEN CIRCUIT
(Pressure sensor circuit)
Diagnosis condition
When ignition switch ON.
Signal (terminal)
Pressure sensor signal
Threshold
When a malfunction is detected in pressure sensor...
Exploded View
1.
Air bag diagnosis sensor unit
Front
Removal and Installation
WARNING:
Before servicing SRS, place the ignition switch in the OFF position, disconnect both battery terminals then wait at least three minutes.
Before disconnecting air bag diagnosis sensor unit harness connectors, be sure to disconnect each harness connector of side curtain air bag modules, front seat belt pre-tensioner, and front side air bag module, to prevent accidental air bag deployment by static electricity and seat belt pre-tensioner operation...