Release the instrument finisher D clips using a suitable tool and remove.
Other information:
Component Function Check
INSPECTION START
Turn ignition switch OFF, and restart engine.
Does the engine start?
YES>>
With CONSULT: GO TO 2.
YES>>
Without CONSULT: GO TO 3.
NO>>
Proceed to Diagnosis Procedure.
CHECK IGNITION SIGNAL FUNCTION
With CONSULT
Perform “POWER BALANCE” in “ACTIVE TEST” mode with CONSULT...
Component Function Check
DATA MONITOR
CONSULT
Select “MEMORY SW 1”, “MEMORY SW 2” and “SET SW” in “Data Monitor” mode of “AUTO DRIVE POS.”.
Check that the function operates normally according to the following conditions:
Monitor item Condition Status
MEMORY SW 1
Memory switch 1
Push
ON
Release
OFF
MEMORY SW 2
Memory switch 2
Push
ON
Release
OFF
SET SW
Set switch
Push
ON
Release
OFF
Is the inspection result normal?
YES>>
Inspection End...