Nissan Murano: Intelligent Forward Collision Warning (I-FCW) / I-FCW system operation

Nissan Murano (Z52) 2015-2024 Owners Manual / Starting and driving / Intelligent Forward Collision Warning (I-FCW) / I-FCW system operation

Nissan Murano. I-FCW system operation

The I-FCW system operates at speeds above approximately 3 mph (5 km/h).

If there is a potential risk of a forward collision, the I-FCW system will warn the driver by blinking the vehicle ahead detection indicator, and sounding an audible alert.

Intelligent Forward Collision Warning (I-FCW)

WARNING Failure to follow the warnings and instructions for proper use of the I-FCW system could result in serious injury or death. The I-FCW system can help warn the driver before a collision occurs but will not avoid a collision...

Turning the I-FCW system on/off

Perform the following steps to turn the I-FCW system on or off. Press the button until “Settings” displays in the vehicle information display and then press the OK button...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Retained Power Operation Does Not Operate Properly

Diagnosis Procedure CHECK FRONT DOOR SWITCH Check (LH and RH) front door switches. Refer to Diagnosis Procedure. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace the malfunctioning parts. CONFIRM THE OPERATION Confirm the operation again...

Nissan Murano (Z52) 2015-2024 Service Manual: P0078 Evt Control Solenoid Valve

DTC Description DTC DETECTION LOGICAn improper voltage is sent to the ECM through exhaust valve timing control solenoid valve. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0078 EX V/T ACT/CIRC-B1 [Exhaust valve timing control solenoid valve (bank 1) circuit] Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from exhaust valve timing control solenoid valve to ECM Threshold An improper voltage is sent to the ECM through exhaust valve timing control solenoid valve Diagnosis delay time — P0084 EX V/T ACT/CIRC-B2 [Exhaust valve timing control solenoid valve (bank 2) circuit] Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from exhaust valve timing control solenoid valve to ECM Threshold An improper voltage is sent to the ECM through exhaust valve timing control solenoid valve Diagnosis delay time — POSSIBLE CAUSEP0078 Harness or connectors (Exhaust valve timing control solenoid valve circuit is open or shorted...