Nissan Murano: Security Control System :: Removal and Installation / Hood Switch
Removal and Installation
The hood switch is part of the hood lock assembly. For removal and installation, refer to Removal and Installation.
Removal and Installation
REMOVALRemove the glove box assembly. Refer to Removal and Installation.
Remove the remote keyless entry receiver bolt.
Disconnect the harness connector from remote keyless entry receiver...
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...
Other information:
The vehicle should be driven with the VDC
system on for most driving conditions.
If the vehicle is stuck in mud or snow, the
VDC system reduces the engine output to
reduce wheel spin. The engine speed will
be reduced even if the accelerator is depressed
to the floor...
Diagnosis Procedure
CHECK POWER SUPPLY
Ignition switch OFF.
Disconnect main power window and door lock/unlock switch connectors.
Ignition switch ON.
Check voltage between main power window and door lock/unlock switch harness connectors and ground...
Categories

Your vehicle has two types of security systems:
Vehicle security system
NISSAN Vehicle Immobilizer System
The vehicle security system provides visual
and audible alarm signals if someone
opens the doors, liftgate or the hood when
the system is armed. It is not, however, a
motion detection type system that activates
when a vehicle is moved or when a
vibration occurs.
read more