Nissan Murano: Security Control System :: Removal and Installation / Remote Keyless Entry Receiver
REMOVAL
Remove the glove box assembly. Refer to Removal and Installation.
Remove the remote keyless entry receiver bolt.
Disconnect the harness connector from remote keyless entry receiver.
Release pawl and remove remote keyless entry receiver from bracket.
INSTALLATION
Installation is in the reverse order of removal.
Immobilizer Control Module
Removal and Installation
RemovalThe immobilizer control module is integrated into the body control module (BCM). For removal and installation, refer to Removal and Installation...
Hood Switch
R..
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: P0966 Pressure Control Solenoid B
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0966 PC SOLENOID B (Pressure Control Solenoid B Control Circuit Low) Diagnosis condition TCM power supply voltage: More than 11 V Signal — Threshold TCM judges that solenoid valve circuit is shorted to ground Diagnosis delay time Maintained for 1 second POSSIBLE CAUSE Harness or connector (Primary pressure solenoid valve circuit shorted to ground) Primary pressure solenoid valve FAIL-SAFE Selector shock is large Start is slow Acceleration is slow Lock-up is not performed DTC Confirmation Procedure PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test...
Nissan Murano (Z52) 2015-2024 Owners Manual: Rear center seat belt
The rear center seat belt has a connector tongue and a seat belt tongue . Both the connector tongue and the seat belt tongue must be securely latched for proper seat belt operation. WARNING Always fasten the connector tongue and the seat belt in the order shown...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- All-Wheel Drive (AWD) (if so equipped)
- Fuel recommendation
- Indicator lights
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
