Nissan Murano: System / Heated Seat System

Nissan Murano (Z52) 2015-2024 Service Manual / Body Interior / Seat :: System Description / System / Heated Seat System

System Description

DESCRIPTION

Heated seat system is activated by heated seat switch while ignition switch is ON, and has the function to warm seat cushion and seat back.
Front heated seat and 2nd row heated seat system are activated by the front and 2nd row heated seat switches while the ignition switch is on. The front and 2nd row heated seat systems have the function to warm the front and 2nd row seat cushions and seat backs.

Lumbar Support System

System Description DESCRIPTION Lumbar support can operate regardless of the ignition switch status, because power supply is always supplied to lumber support switch (with automatic drive positioner)...

Seat :: Ecu Diagnosis Information. Climate Controlled Seat Control Unit Lh/rh

Reference Value TERMINAL LAYOUTPHYSICAL VALUES Terminal No. (Wire color) Description Condition Voltage (Approx.) + - Signal name Input/Output 2 (BR) Ground Seat cushion heater sensor signal Input Ignition switch ON Climate controlled seat switch select HEAT or COOL 1...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Rear Reflex Reflector

Exploded View 1. Rear reflex reflector Clip Removal and Installation REMOVALRemove rear bumper fascia. Refer to Removal and Installation. Remove rear reflex reflector fixing screw and pawls and then remove rear reflex reflector.INSTALLATIONInstallation is in the reverse order of removal...

Nissan Murano (Z52) 2015-2024 Service Manual: P0863 Tcm Communication

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0863 CONTROL UNIT (CAN) (TCM Communication Circuit) Diagnosis condition Engine is started Signal — Threshold An error is detected at the initial CAN diagnosis of TCM Diagnosis delay time Within 1 second POSSIBLE CAUSETCMFAIL-SAFE Selector shock is large Start is slow Acceleration is slow Lock-up is not performed DTC Confirmation Procedure PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test...