Nissan Murano: Headlight control switch / Headlight beam select

To select the high beam
function, push
the lever forward while the low beams
are on. The high beam lights come on
and the
indicator light illuminates.
Pull the lever back to return to
the low
beams.
Pulling and releasing the lever
flashes
the headlight high beams on and off.
The low beams do not need to be on
for this to function.
The autolight system allows the headlights
to turn on and off automatically. The autolight
system can:
Turn on the headlights, front parking,
tail, license plate and instrument panel
lights automatically when it is dark...
The High Beam Assist system will operate
when the vehicle is driven at speeds of approximately
25mph(40 km/h) and above. If
an oncoming vehicle or leading vehicle appears
in front of your vehicle when the
headlight high beam is on, the headlight
will be switched to the low beamautomatically...
Other information:
Removal and Installation
REMOVALRemove the center console side finisher (LH). Refer to Exploded View.
Remove the instrument lower panel LH. Refer to Removal and Installation.
Remove the screws (A) and the front foot duct (LH) (1).
Remove the mode door motor screws...
Component Function Check
CHECK ORVR FUNCTION
Check whether the following symptoms are present.
Fuel odor from EVAP canister is strong.
Cannot refuel/Fuel odor from the fuel filler opening is strong while refueling.
Are any symptoms present?
YES>>
Proceed to Diagnosis Procedure...