Nissan Murano: Body Exterior, Doors, Roof & Vehicle Security / Glass & Window System :: Preparation. Preparation

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Glass & Window System :: Preparation. Preparation

Special Service Tool

The actual shape of the tools may differ from those illustrated here.
Tool number (TechMate No.) Tool name		Description
— (J-39570) Chassis Ear		Locating the noise
— (J-50397) NISSAN Squeak and Rattle Kit		Repairing the cause of noise
— (J-46534) Trim Tool Set		Removing trim components

Commercial Service Tool

(TechMate No.) Tool name		Description
(J-39565) Engine Ear		Locating the noise
( — ) Suction Lifter		Holding door glass

Glass & Window System :: Precaution. Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...

Glass & Window System :: Symptom Diagnosis. Squeak and Rattle Trouble Diagnoses

Work Flow CUSTOMER INTERVIEWInterview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any customer's comments; refer to Diagnostic Worksheet...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Automatic Back Door Warning Does Not Operate. Buzzer

Diagnosis Procedure Automatic back door warning buzzer does not operate when automatic back door warning function is performed.CHECK DTC WITH AUTOMATIC BACK DOOR CONTROL MODULE Check that DTC is not detected with automatic back door control module. Is the inspection result normal? YES>> GO TO 2...

Nissan Murano (Z52) 2015-2024 Service Manual: Ignition Signal

Component Function Check INSPECTION START Turn ignition switch OFF, and restart engine. Does the engine start? YES>> With CONSULT: GO TO 2. YES>> Without CONSULT: GO TO 3. NO>> Proceed to Diagnosis Procedure. CHECK IGNITION SIGNAL FUNCTION With CONSULT Perform “POWER BALANCE” in “ACTIVE TEST” mode with CONSULT...