Nissan Murano: Fuel Filler Lid Opener / Fuel Filler Lid Lock
Removal and Installation
REMOVAL
Remove luggage side lower finisher (LH). Refer to Removal and Installation.
Disconnect the fuel filler lid release cable from the fuel filler lid lock.
Rotate fuel filler lid lock to release pawls and remove.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installation, check fuel filler lid open/close and lock/unlock operation.
Exploded View
1.
Fuel filler lid
2.
Fuel filler lid release handle and hood lock
3.
Fuel filler release cable
4.
Fuel filler lid lock
Clip
Removal and Installation
REMOVALRemove fuel cap pin...
Removal and Installation
REMOVALRemove fuel filler lid/hood lock release handle bolts (A).
Disconnect the fuel filler lid release cable (2) from the fuel filler lid release handle (1)...
Other information:
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition
C1143
ST ANG SEN CIRCUIT
(Steering angle sensor circuit)
Diagnosis condition
When ignition switch ON.
Signal (terminal)
Steering angle sensor signal
Threshold
Steering angle sensor signal failure
Diagnosis delay time
2 seconds or more
POSSIBLE CAUSE
Harness or connectors
Steering angle sensor
Power steering control module
FAIL-SAFECertain steering assist force
DTC Confirmation Procedure
PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place the ignition switch in the OFF position and wait at least 10 seconds before conducting the next test...
Diagnosis Procedure
All doors do not lock/unlock using Intelligent Key button. (One Intelligent Key has the symptom, other keys operate normally.)NOTE:
Before starting diagnosis check that vehicle condition is as shown in “Conditions of Nissan Murano vehicle”, and check each symptom...