Nissan Murano: Fuel Filler Lid Opener / Fuel Filler Lid Release Cable
REMOVAL
Remove fuel filler lid/hood lock release handle bolts (A).
Disconnect the fuel filler lid release cable (2) from the fuel filler lid release handle (1).
Remove dash side finisher (LH). Refer to Removal and Installation.
Remove center pillar lower finisher (LH). Refer to Removal and Installation.
Remove luggage side lower finisher (LH). Refer to Removal and Installation.
Disconnect the fuel filler lid release cable from the fuel filler lid lock.
Release clips and remove fuel filler lid release cable.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installation, check fuel filler lid open/close and lock/unlock operation.
Fuel Filler Lid Lock
Removal and Installation
REMOVALRemove luggage side lower finisher (LH). Refer to Removal and Installation.
Disconnect the fuel filler lid release cable from the fuel filler lid lock...
Fuel Filler Lid Release Handle
Removal and Installation
REMOVALRemove fuel filler lid/hood lock release handle bolts (A).
Disconnect fuel filler lid release cable (2) from fuel filler lid release handle (1)...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: P0053 A/f Sensor 1 Heater
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0053 HO2S1 HTR B1 (HO2S heater resistance bank 1 sensor 1) Diagnosis condition — Signal (terminal) A/F sensor 1 heater (bank 1) signal Threshold During engine running, weighted average of A/F sensor internal resistance is out of the normal range Diagnosis delay time — POSSIBLE CAUSE Harness and connectors [A/F sensor 1 (bank 1) heater circuit is open or shorted...
Nissan Murano (Z52) 2015-2024 Owners Manual: NISSAN Vehicle Immobilizer System
The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of a registered key. Never leave these keys in the vehicle. FCC Notice: For USA: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device maynot cause harmful interference,and (2) this device must accept any interference received, including interference that may cause undesired operation...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Passenger compartment
- Vehicle Dynamic Control (VDC) OFF switch
- Fuel recommendation
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
