Nissan Murano: Fuel-filler door / Fuel-filler cap

Nissan Murano (Z52) 2015-2024 Owners Manual / Pre-driving checks and adjustments / Fuel-filler door / Fuel-filler cap

Opener operation

The fuel-filler door release is located below the instrument panel. To open the fuel-filler door, pull the release. To lock, close the fuelfiller door securely...

Fuel-filler cap

WARNING Gasoline is extremely flammable and highly explosive under certain conditions. You could be burned or seriously injured if it is misused or mishandled...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P0740 Torque Converter


DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0740 TORQUE CONVERTER (Torque Converter Clutch Circuit/Open) Diagnosis condition When all of the following conditions are satisfied: TCM power supply voltage: More than 11 V P0743 is not detected Signal — Threshold TCM judges that solenoid valve circuit is open Diagnosis delay time Maintained for 5 seconds POSSIBLE CAUSE Harness or connector (Torque converter clutch solenoid valve circuit is open or shorted to power supply) Torque converter clutch solenoid valve FAIL-SAFE Start is slow Acceleration is slow Lock-up is not performed DTC Confirmation Procedure CAUTION: Be careful of the driving speed...

Nissan Murano (Z52) 2015-2024 Service Manual: Led Headlamp Operation Inspection


Work Procedure CHECK START In the cool LED status (wait for more than 10 minutes after turning headlamp OFF), turn ON and turn OFF headlamp several times. Check that headlamp operates normally each time. In the cool LED status, turn headlamp ON, wait until headlamp enters the stable status (approximately 5 minutes after turning headlamp ON) and then check that headlamp operates normally without blinking or flickering...

Categories

LATCH (Lower Anchors and Tethers for CHildren) system

Nissan Murano. LATCH (Lower Anchors and Tethers for CHildren) system

LATCH system lower anchor locations - bench seat

Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.

read more

 
Copyright © 2026 www.nimurano.com