Nissan Murano: Dtc/circuit Diagnosis / P0741 Torque Converter

DTC Description

DTC DETECTION LOGIC

POSSIBLE CAUSE

• Torque converter clutch solenoid valve

• Control valve assembly

• Torque converter

FAIL-SAFE

• Start is slow

• Acceleration is slow

• Lock-up is not performed

CAUTION:

Be careful of the driving speed.

PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

GO TO 2.

PREPARATION BEFORE OPERATION

With CONSULT

1. Start the engine.

2. Select “Data Monitor” in “TRANSMISSION”.

3. Select “FLUID TEMP”.

4. Confirm that the CVT fluid temperature is in the following range.

   FLUID TEMP

   : 20°C (68°F) or more

With GST

1. Start the engine.

2. Set the CVT fluid to 20°C (68°F) or more.

   NOTE:

   When the ambient temperature is 20°C (68°F), the CVT fluid usually increases to 50 to 80°C (122 to 176°F) with driving in an urban area for approximately 10 minutes.

Is the CVT fluid 20°C (68°F) or more?

GO TO 3.

1. Warm the transaxle.

2. GO TO 3.

CHECK DTC DETECTION

1. Drive the Nissan Murano vehicle.

2. Maintain the following conditions for 30 seconds or more.

   Selector lever	: “D” position
   Accelerator pedal position	: 0.5/8 or more
   Nissan Murano Vehicle speed	: 40 km/h (25 MPH) or more

3. Stop the vehicle.

4. Check the first trip DTC.

Is “P0741” detected?

Go to Diagnosis Procedure.

To check malfunction symptom before repair: Refer to Intermittent Incident.

Confirmation after repair: INSPECTION END

CHECK INTERMITTENT INCIDNT

Refer to Intermittent Incident.

Is the inspection result normal?

Replace transaxle assembly. Refer to Removal and Installation (front wheel drive) or Removal and Installation (all wheel drive).

Repair or replace the malfunction items.