Nissan Murano: Wiper & Washer :: Dtc/circuit Diagnosis / Front Wiper Motor Ground Circuit

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Controls / Wiper & Washer :: Dtc/circuit Diagnosis / Front Wiper Motor Ground Circuit

Diagnosis Procedure

CHECK FRONT WIPER MOTOR GROUND CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect front wiper motor connector.

  3. Check continuity between front wiper motor harness connector and ground.

Front wiper motor Continuity
Connector Terminal
E23 5 Ground Yes

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Repair or replace harness.

    Front Wiper Stop Position Signal Circuit

    Component Function Check CHECK FRONT WIPER STOP POSITION SIGNAL CONSULT Select “WIP AUTO STOP” in “Data Monitor” mode of “IPDM E/R”. Operate the front wiper...

    Front and Rear Washer Motor Circuit

    Diagnosis Procedure CHECK FRONT AND REAR WASHER MOTOR FUSE Ignition switch OFF. Check that the following fuse is not blown: Component Location Fuse No...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: U1000 Can Comm Circuit


    DTC Description CAN (Controller Area Network) is a serial communication system for real time application. It is an on-Nissan Murano vehicle multiplex communication system with high data communication speed and excellent error detection ability. Many electronic control units are equipped in Nissan Murano vehicles, and each control unit shares information and links with other control units during operation (not independent)...

    Nissan Murano (Z52) 2015-2024 Service Manual: Disc Brake Rotor


    Inspection and Adjustment INSPECTIONAppearanceCheck surface of disc brake rotor for uneven wear, cracks or damage. Replace if any abnormal conditions exist.RunoutCheck the wheel bearing axial end play before the inspection. Refer to Inspection. Secure the disc brake rotor to the wheel hub and bearing assembly with wheel nuts at two wheel nut locations...

    Categories

    Luggage hooks

    Nissan Murano. Luggage hooks

    When securing items using luggage hooks located on the back of the seat or side finisher do not apply a load over more than 6.5 lbs. (29 N) to a single hook.

    The luggage hooks that are located on the floor should have loads less than 110 lbs. (490 N) to a single hook.

    read more

     
    Copyright © 2026 www.nimurano.com