Nissan Murano: Front Washer Nozzle and Tube / Front Washer Tube

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Controls / Wiper & Washer :: Removal and Installation / Front Washer Nozzle and Tube / Front Washer Tube

Removal and Installation

REMOVAL

Remove the hood insulator. Refer to Exploded View.

Remove the hoodledge cover (RH). Refer to Removal and Installation.

Disconnect the front washer tube from the front washer nozzle. Refer to Removal and Installation.

Remove the front fender protector (RH). Refer to Removal and Installation.

Disconnect the front washer tube from the front and rear washer motor.

Release clips and remove the front washer tube.

INSTALLATION

Installation is in the reverse order of removal.

    Front Washer Nozzle

    Removal and Installation REMOVALRelease the pawl and remove the front washer nozzle from the hood. : Pawl Disconnect the front washer tube from the front washer nozzle...

    Front Wiper Arm

    Exploded View 1. Front wiper blade (RH) 2. Front wiper arm (RH) 3. Front wiper arm cover (RH) 4. Front wiper arm cover (LH) 5. Front wiper arm (LH) 6...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: System


    System Description SYSTEM DIAGRAMAV Control Unit Input Signal (AV Communication)Transmit unitSignal name Combination meter Steering switch signal AV Control Unit Input Signal (CAN Communication)Transmit unitSignal name BCM Door switches state signal Combination meter Nissan Murano Vehicle speed signal Hand brake switch signal ECM Engine RPM Signal IPDM E/R Battery voltage signal AUDIO SYSTEMThe audio system consists of the following components: AV control unit Instrument panel tweeters Front door speakers Rear door speakers Front auxiliary input jacks Front auxiliary input jacks control unit Microphone Steering switches Combination meter Combination switch (spiral cable) Accessory relay-2 Antenna base (AM/FM antenna, antenna amp...

    Nissan Murano (Z52) 2015-2024 Service Manual: P0037 Ho2s2 Heater


    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0037 HO2S2 HTR (B1) (HO2S heater control circuit low bank 1 sensor 2) A Diagnosis condition — Signal (terminal) Voltage signal transmitted from heated oxygen sensor 2 heater to ECM Threshold An excessively low voltage signal is sent to ECM through the heated oxygen sensor 2 heater Diagnosis delay time — B Diagnosis condition — Signal (terminal) — Threshold ECM detects the heated oxygen sensor 2 heater circuit is short to ground...

    Categories

    read more

     
    Copyright © 2026 www.nimurano.com