Nissan Murano: Removal and Installation / Front Door Speaker

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Information & Multimedia / Audio, Visual & Navigation System :: Navigation Without Bose / Removal and Installation / Front Door Speaker

Removal and Installation

REMOVAL

Remove front door finisher. Refer to Removal and Installation.

Disconnect the harness connector (A) from front door speaker and remove screws to remove front door speaker (1).

INSTALLATION

Installation is in the reverse order of removal.

    Instrument Panel Tweeter

    Removal and Installation REMOVALRemove instrument panel tweeter grille (LH\RH). Refer to Exploded View. Disconnect the harness connector from instrument panel tweeter and remove screws (A) to remove instrument panel tweeter (1)...

    Roof Antenna

    Removal and Installation REMOVALLower headlining (rear). Refer to Exploded View. Disconnect the harness connectors from the antenna feeder. Loosen bolt (A) and remove roof antenna (1)...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: P0222 Tp Sensor


    DTC Description DTC DETECTION LOGIC An excessively low voltage from the TP sensor 1 is sent to ECM. An excessively high voltage from the TP sensor 1 is sent to ECM. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0222 TP SEN 1/CIRC-B1 (Throttle/Pedal position sensor/switch “B” circuit low) Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from TP sensor 1 to ECM Threshold An excessively low voltage from the TP sensor 1 is sent to ECM Diagnosis delay time — P0223 TP SEN 1/CIRC-B1 (Throttle/Pedal position sensor/switch “B” circuit high) Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from TP sensor 1 to ECM Threshold An excessively high voltage from the TP sensor 1 is sent to ECM Diagnosis delay time — POSSIBLE CAUSEP0222 Harness or connectors (TP sensor 1 circuit is open or shorted...

    Nissan Murano (Z52) 2015-2024 Service Manual: B2796 Fr Sw Comm Error


    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2796 FR SW COMM ERROR (Front switch communication error) Diagnosis condition When ignition switch is ON. Signal (terminal) - Threshold - Diagnosis delay time 2 seconds or more POSSIBLE CAUSE A/C switch assembly A/C auto amp...

    Categories

    Front manual seat adjustment (if so equipped)

    Your vehicle seats can be adjusted manually. For additional information about adjusting the seats, refer to the steps outlined in this section.

    Forward and backward

    Nissan Murano. Front manual seat adjustment (if so equipped)

    read more

     
    Copyright © 2026 www.nimurano.com