The driver side door request switch and driver side outside handle are serviced as an assembly. Refer to Removal and Installation.
Other information:
Removal and Installation
REMOVALRemove front grille. Refer to Removal and Installation.
Disconnect secondary latch cable from hood lock assembly.
Remove bolts and secondary latch.INSTALLATIONInstallation is in the reverse order of removal.CAUTION:
Tighten bolts to specified torque...
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition
C1602
NO TUNING SET
(No tuning set)
Diagnosis condition
When ignition switch ON.
Signal (terminal)
—
Threshold
Information in power steering module is not the same
Diagnosis delay time
—
POSSIBLE CAUSE
Harness or connector
Power steering control module
Battery power supply circuit
Ignition power supply circuit
Battery
Fuse
Ground circuit
FAIL-SAFEManual steering state
DTC Confirmation Procedure
PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place the ignition switch in the OFF position and wait at least 10 seconds before conducting the next test...