Nissan Murano: Body Exterior, Doors, Roof & Vehicle Security / Door & Lock :: Preparation. Preparation

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Door & Lock :: Preparation. Preparation

Special Service Tool

The actual shape of the tools may differ from those illustrated here.
Tool number (TechMate No.) Tool name		Description
— (J-39570) Chassis Ear		Locating the noise
— (J-50397) Squeak and Rattle Kit		Repairing the cause of noise
— (J-43241) Remote Keyless Entry Tester		Used to test keyfobs
— (J-50190) Signal Tech II		Activate and display TPMS transmitter IDs Display tire pressure reported by the TPMS transmitter Read TPMS DTCs Register TPMS transmitter IDs Check Intelligent Key relative signal strength Confirm Nissan Murano vehicle Intelligent Key antenna signal strength Compatible with future sensors Equipped with a display
KV48105501 (J-45295-A) Transmitter Activation Tool		Activate TPMS transmitter IDs Compatible with future sensors Equipped with a display (KV48105501 only)
— (J-46534) Trim Tool Set		Removing trim components

Commercial Service Tool

(TechMate No.) Tool name		Description
(J-39565) Engine Ear		Locating the noise
( — ) Power Tool		Loosening nuts, screws and bolts

Door & Lock :: Precaution. Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...

Door & Lock :: System Description

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Roof Antenna

Removal and Installation REMOVALLower headlining (rear). Refer to Exploded View. Disconnect the harness connectors from the antenna feeder. Loosen bolt (A) and remove roof antenna (1). INSTALLATIONInstallation is in the reverse order of removal. Roof antenna nut : 8 N·m (0...

Nissan Murano (Z52) 2015-2024 Service Manual: C1b52-17 Blind Spot Warning Indicator Open Circuit

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1B52-17 BSW/BSI IND OPEN CIR (Blind Spot Warning indicator open circuit) Diagnosis condition When ignition switch is ON. Signal (terminal) – Threshold Open circuit in Blind Spot Warning indicator circuit is detected Diagnosis delay time – POSSIBLE CAUSE Blind Spot Warning indicator LH circuit Blind Spot Warning indicator LH Side radar LH FAIL-SAFEThe following systems are canceled: Blind Spot Warning (BSW) Rear Cross Traffic Alert (RCTA) DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Start the engine...