Nissan Murano: Body Exterior, Doors, Roof & Vehicle Security / Door & Lock :: Precaution. Precautions

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Door & Lock :: Precaution. Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions.

Information necessary to service the system safely is included in the “SRS AIR BAG” and “SEAT BELT” sections of this Service Manual.

WARNING:

Always observe the following items for preventing accidental activation:

  • To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision that would result in air bag inflation, it is recommended that all maintenance and repair be performed by an authorized NISSAN/INFINITI dealer.

  • Improper repair, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see “SRS AIR BAG”.

  • Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

WARNING:

Always observe the following items for preventing accidental activation:

  • When working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with the ignition/power switch ON or engine running, never use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.

  • When using air or electric power tools or hammers, always switch the ignition/power switch OFF, disconnect the 12V battery or batteries, and wait at least 3 minutes before performing any service.

Precaution for Servicing Doors and Locks

WARNING:

Radio waves could adversely affect electric medical equipment. Those who use a pacemaker should contact the electric medical equipment manufacturer for the possible influences before use.

  • After removing and installing the opening/closing parts, be sure to carry out fitting adjustments to check their operation.

  • Check the lubrication level, damage, and wear of each part. If necessary, grease or replace it.

  • When removing or disassembling each component, be careful not to damage or deform it. If a component may be subject to interference, be sure to protect it with a shop cloth.

  • When removing (disengaging) components with a screwdriver or similar tool, be sure to wrap the component with a shop cloth or vinyl tape to protect it.

    NOTE:

    Do not lubricate front or rear door locks.

  • Protect the removed parts with a shop cloth and prevent them from being dropped.

  • Replace a deformed or damaged clip.

  • If a part is specified as a non-reusable part, always replace it with a new one.

  • Be sure to tighten bolts and nuts securely to the specified torque.

  • After installation is complete, be sure to check that each part works properly.

  • Follow the steps below to clean components:

    • Water soluble dirt:

      1. Dip a soft cloth into lukewarm water, wring the water out of the cloth and wipe the dirty area.

      2. Then rub with a soft, dry cloth.

    • Oily dirt:

      1. Dip a soft cloth into lukewarm water with mild detergent (concentration: within 2 to 3%) and wipe the dirty area.

      2. Then dip a cloth into fresh water, wring the water out of the cloth and wipe the detergent off.

      3. Then rub with a soft, dry cloth.

    • Do not use organic solvent such as thinner, benzene, alcohol or gasoline.

    • For genuine leather seats, use a genuine leather seat cleaner.

    Body Exterior, Doors, Roof & Vehicle Security

    ..

    Door & Lock :: Preparation. Preparation

    Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name   Description   — (J-39570) Chassis Ear Locating the noise   — (J-50397) Squeak and Rattle Kit Repairing the cause of noise   — (J-43241) Remote Keyless Entry Tester Used to test keyfobs   — (J-50190) Signal Tech II Activate and display TPMS transmitter IDs Display tire pressure reported by the TPMS transmitter Read TPMS DTCs Register TPMS transmitter IDs Check Intelligent Key relative signal strength Confirm Nissan Murano vehicle Intelligent Key antenna signal strength Compatible with future sensors Equipped with a display KV48105501 (J-45295-A) Transmitter Activation Tool Activate TPMS transmitter IDs Compatible with future sensors Equipped with a display (KV48105501 only)   — (J-46534) Trim Tool Set Removing trim components Commercial Service Tool (TechMate No...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Component Parts. Tire Pressure Monitoring System


    Component Parts Location A. LH side of instrument panel (view with instrument panel removed) B. Combination meter (view with combination meter removed) C. RH side of instrument panel (view with instrument panel removed) D. Wheel (view with wheel and tire removed) E...

    Nissan Murano (Z52) 2015-2024 Service Manual: General Information :: Vehicle Information. Identification Information


    Model Variation FWD Model Body Engine Transmission Grade Destination Federal Wagon VQ35DE CVT S TLJALPW-EUA SV TLJALQW-EUA SL TLJALRW-EUA Platinum TLJALSW-EUA AWD Model Body Engine Transmission Grade Destination Federal Canada Wagon VQ35DE CVT S TLJNLPW-EUA TLJNLPW-ENA SV TLJNLQW-EUA TLJNLQW-ENA SL TLJNLRW-EUA TLJNLRW-ENA Platinum TLJNLSW-EUA TLJNLSW-ENA Prefix and suffix designations Position Character Qualifier Definition 1 T Body type T: SUV 2 LJ Engine LJ: VQ35DE 3 4 A Axle A: FWD N: AWD 5 L Drive L: LH 6 P Grade P: S Q: SV R: SL S: Platinum 7 W Transmission W: CVT 8 Z52 Model Z52: Murano 9 10 11 E Intake E: EGI 12 U Zone N: Canada U: Federal 13 A Payload A: Regular (1,500 lbs...

    Categories

    read more

     
    Copyright © 2026 www.nimurano.com