Nissan Murano: Door & Lock :: Ecu Diagnosis Information / Bcm, Ipdm E/r

Motion Activated Back Door Control Unit

Reference Value TERMINAL LAYOUTPHYSICAL VALUES Terminal No. (Wire color) Description Condition Voltage (Approx.) (+) (–) Signal name Input/Output 1 (L) Ground Serial communication Input/Output — — 2 (V) Ground Power supply (BAT) Input — Battery voltage 3 (B) Ground Ground — — 0 V 4 (W) Ground Motion activated back door sensor (upper) input signal Input — — 5 (W) Ground Motion activated back door sensor (upper) output signal Input — — 6 (W) Ground Motion activated back door sensor (lower) input signal Input — — 7 (W) Ground Motion activated back door sensor (lower) output signal Input — — NOTE: Voltage generated in communication circuit between motion activated back door sensor and motion activated back door control unit is extremely low and therefore cannot be measured...

Door & Lock :: Basic Inspection

..

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Fuel Injector

Component Function Check INSPECTION START Turn ignition switch to START. Are any cylinders ignited? YES>> GO TO 2. NO>> Proceed to Diagnosis Procedure. CHECK FUEL INJECTOR FUNCTION With CONSULT Start engine. Perform “POWER BALANCE” in “ACTIVE TEST” mode with CONSULT...

Nissan Murano (Z52) 2015-2024 Service Manual: Telematics Switch

Removal and Installation REMOVALRemove the map lamp assembly. Refer to Removal and Installation. Remove the connector and screws . Remove the telematics switch with the map lamp assembly finisher as a single unit from the map lamp assembly. Remove the telematics switch , stretching pawls of the map lamp assembly finisher ...