Nissan Murano: Lane Camera (lane Camera Unit) / C1b00-04 Camera Unit Malf

Nissan Murano (Z52) 2015-2024 Service Manual / Cruise Control & Driver Assistance / Driver Assistance System :: Driver Assistance System / Dtc/circuit Diagnosis / Lane Camera (lane Camera Unit) / C1b00-04 Camera Unit Malf

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
C1B00-04

CAMERA UNIT MALF

(Camera unit malfunction)
Diagnosis condition When ignition switch is ON.
Signal (terminal) -
Threshold
  • Configuration of the lane camera unit is not completed.

  • If lane camera unit is malfunctioning.

Diagnosis delay time 5 seconds or more.

POSSIBLE CAUSE

  • Configuration of the lane camera unit is not completed

  • Lane camera unit

FAIL-SAFE

The following systems are canceled:

  • Lane Departure Warning (LDW)

  • Intelligent Lane Intervention (I-LI)

  • Automatic Emergency Braking (AEB) with pedestrian detection

  • Automatic Emergency Braking (AEB)

  • Traffic Sign Recognition (TSR)

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Start the engine.

  2. Perform “All DTC Reading”.

  3. Check “Self Diagnostic Result” mode of “LANE CAMERA”.

Is DTC C1B00–04 detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK SELF-DIAGNOSIS RESULTS

Check if any DTC other than “C1B00-04”, “C1B00-41”, “C1B00-44”, “C1B00-45”, “C1B00-46”, “C1B00-47”, “C1B00-48”, “C1B00-49”, “C1B00-52”, “C1B00-56”, “C1B00-57”, and “C1B00-87” is detected in “Self Diagnostic Result” of “LANE CAMERA”.

Is any DTC detected?

YES>>

Perform diagnosis on the detected DTC and repair or replace the malfunctioning parts. Refer to DTC Index.

NO>>

Replace the lane camera unit. Refer to Removal and Installation.

    Lane Camera (lane Camera Unit)

    ..

    C1b00-4b Camera Unit Malf

    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1B00-4B CAMERA UNIT MALF (Camera unit malfunction) Diagnosis condition When ignition switch is ON...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Aeb Warning Lamp Is Blinking


    Symptom Description The AEB warning lamp is blinking. Refer to Diagnosis Procedure.NOTE: When any of the following conditions, the AEB warning lamp blinks: The distance sensor area of the front of the Nissan Murano vehicle is covered with dirt or is obstructed The interior temperature of the vehicle is extremely high The windshield is dirty, frosted, fogged up, or damaged in front of the lane camera unit The lane camera unit or the lane camera unit bracket is not mounted properly Diagnosis Procedure CHECK THE WINDSHIELD Check if the windshield is dirty, frosted, fogged up, or damaged in front of the lane camera unit...

    Nissan Murano (Z52) 2015-2024 Owners Manual: NISSAN Advanced Air Bag System (front seats)


    Supplemental front-impact air bag modules Air bag Control Unit (ACU) Occupant classification sensor (weight sensor) Front seat-mounted side-impact supplemental air bag modules Roof-mounted curtain side-impact and rollover supplemental air bags Roof-mounted curtain side-impact and rollover supplemental air bag inflators Rear outboard seat-mounted sideimpact supplemental air bag modules Seat belt with pretensioner(s) (rear outboard seats) Satellite sensors Seat belt with pretensioner(s) (front seats) Pressure sensors in door (driver’s side shown; front passenger side is similar) Driver and passenger supplemental knee air bags Crash zone sensor WARNING To ensure proper operation of the passenger’s NISSAN Advanced Air Bag System, please observe the following items...

    Categories

    Fuel gauge

    Nissan Murano. Fuel gauge

    The gauge indicates the approximate fuel level in the tank.

    The gauge may move slightly during braking, turning, acceleration, or going up or down hills.

    The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.

    read more

     
    Copyright © 2026 www.nimurano.com