Nissan Murano: Changing a flat tire / Blocking wheels

Nissan Murano (Z52) 2015-2024 Owners Manual / In case of emergency / Flat tire / Changing a flat tire / Blocking wheels

Place suitable blocks at both the front and back of the wheel diagonally opposite the flat tire to prevent the vehicle from moving when it is jacked up.

WARNING

Be sure to block the wheel as the vehicle maymove and result in personal injury.

    Stopping the vehicle

    Safelymove the vehicle off the road and away from traffic. Turn on the hazard warning flashers. Park on a level surface and apply the parking brake...

    Getting the spare tire and tools

    Open the rear liftgate. Pull up on the handle to lift the carpeted floorboard and attach the hook as shown. Open the storage compartment by pulling on the strap to locate the jack and tools ...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Mirrors :: Dtc/circuit Diagnosis. Main Power Window and Door Mirror Switch


    Component Inspection NOTE: If equipped with ADP, refer to Component Function Check (for select switch) or Component Function Check (for mirror switch). CHECK MIRROR SWITCH & SELECT SWITCH Ignition switch OFF. Disconnect door mirror remote control switch connector...

    Nissan Murano (Z52) 2015-2024 Service Manual: P1225 Tp Sensor


    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1225 CTP LEARNING-B1 (Closed throttle position learning performance) Diagnosis condition Ignition switch ON Signal (terminal) Electric throttle control actuator signal Threshold Closed throttle position learning value is excessively low Diagnosis delay time — POSSIBLE CAUSE Electric throttle control actuator (TP sensor 1 and 2) FAIL-SAFENot applicable DTC Confirmation Procedure PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test...

    Categories

    Fuel gauge

    Nissan Murano. Fuel gauge

    The gauge indicates the approximate fuel level in the tank.

    The gauge may move slightly during braking, turning, acceleration, or going up or down hills.

    The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.

    read more

     
    Copyright © 2026 www.nimurano.com