Nissan Murano: Lan System :: Can Gateway / Basic Inspection

Ecu Diagnosis Information. 3ch Can Gateway

Reference Value TERMINAL LAYOUTPHYSICAL VALUES Terminal No. (Wire color) Description Condition Standard Reference value + – Signal name Input/ Output 1 (L) — Nissan Murano Vehicle CAN communication-H Input/ Output — — — 2 (P) — Nissan Murano Vehicle CAN communication-L Input/ Output — — — 3 (L) — Diagnostic CAN communication-H Input/ Output — — — 4 (P) — Diagnostic CAN communication-L Input/ Output — — — 5 (BG) 6 (B) 7 (B) Ignition power supply Input Ignition switch ON 7 – 16 V Battery voltage 8 (BG) 6 (B) 7 (B) Battery power supply Input Ignition switch OFF 6 – 16 V Battery voltage 9 (L) — IT CAN communication-H — — — — 10 (P) — IT CAN communication-L — — — — 11 (L) — Diagnostic CAN communication-H Input/ Output — — — 12 (P) — Diagnostic CAN communication-L Input/ Output — — — 13 (L) — IT CAN communication-H — — — — 14 (P) — IT CAN communication-L — — — — DTC Inspection Priority Chart If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart...

Additional Service When Replacing Can Gateway. 3ch Can Gateway

Description For work procedure, refer to Work Procedure.BEFORE REPLACEMENTWhen replacing 3CH CAN gateway, save or print current vehicle specification (Type ID) with CONSULT configuration before replacement...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Satellite Sensor

Exploded View 1. Front door satellite sensor 2. Front side air bag satellite sensor 3. Rear side air bag satellite sensor A. Front door satellite sensor harness connector B. Front side air bag satellite sensor harness connector C...

Nissan Murano (Z52) 2015-2024 Service Manual: Sliding Sensor

Component Function Check DATA MONITOR CONSULT Select “SLIDE PULSE” in “Data Monitor” mode of “AUTO DRIVE POS.”. Check that the function operates normally according to the following conditions: Monitor item Condition Value SLIDE PULSE Seat sliding Operate (forward) Change (decrease) Operate (backward) Change (increase) Release No change Is the inspection result normal? YES>> Inspection End...