Nissan Murano: Back Door Trim / Back Door Side Finisher

Nissan Murano (Z52) 2015-2024 Service Manual / Body Interior / Interior :: Removal and Installation / Back Door Trim / Back Door Side Finisher

Removal and Installation

REMOVAL

Remove back door upper finisher. Refer to Removal and Installation.

Remove back door lower finisher. Refer to Removal and Installation.

Release back door side finisher metal clips using a suitable tool then remove back door side finisher.

: Metal clip

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

Visually check metal clips for deformation and damage during installation. Replace with new ones if necessary.

When installing back door side finisher, check that metal clips are securely placed in body panel holes.

Back Door Lower Finisher

Removal and Installation REMOVALRelease clips from back door lower finisher (1) using a suitable tool. : Clip Remove back door pull handle. Refer to Exploded View...

Instrument Panel :: Precaution. Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P0111 Iat Sensor

DTC Description DTC DETECTION LOGICThe comparison result of signals transmitted to ECM from each temperature sensor (IAT sensor, ECT sensor, FTT sensor, and EOT sensor) shows that the voltage signal of the IAT sensor is higher/lower than that of other temperature sensors when the engine is started with its cold state...

Nissan Murano (Z52) 2015-2024 Service Manual: B259a Room Lamp Fuse Blown

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition B259A ROOM LAMP FUSE BLOWN (Room lamp fuse blown) Diagnosis condition When ignition switch ON. Signal (terminal) BCM power circuit (terminal 131 and ground) Threshold Approx...