Nissan Murano: Dtc/circuit Diagnosis / B1341 Head Unit
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B1341–16 |
Head unit (Audio unit) |
[VB–LOW] | Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | – | |||
| Threshold | – | |||
| Diagnosis delay time | 30 seconds or more | |||
| B1341–17 | [VB–HIGH] | Diagnosis condition | When ignition switch is ON. | |
| Signal (terminal) | – | |||
| Threshold | – | |||
| Diagnosis delay time | 30 seconds or more | |||
| B1341–49 | [—] | Diagnosis condition | When ignition switch is ON. | |
| Signal (terminal) | – | |||
| Threshold | – | |||
| Diagnosis delay time | 30 seconds or more | |||
| B1341–55 | [CONFIG] | Diagnosis condition | When ignition switch is ON. | |
| Signal (terminal) | – | |||
| Threshold | – | |||
| Diagnosis delay time | 30 seconds or more | |||
| B1341–98 | [TEMP] | Diagnosis condition | When ignition switch is ON. | |
| Signal (terminal) | – | |||
| Threshold | – | |||
| Diagnosis delay time | 30 seconds or more | |||
POSSIBLE CAUSE
-
Charging system malfunction
-
Audio unit configuration
-
Audio unit
FAIL-SAFE
-
Failure type byte 16: battery protection shuts Audio unit down 60 seconds after low voltage condition
-
Failure type byte 17:
-
Audio unit display inoperative
-
Audio output is inoperative
-
-
Failure type byte 49: Audio unit internal failure
-
Failure type byte 55: Audio unit configuration error
-
Failure type byte 98: Audio unit shuts down after 5 seconds
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Ignition switch OFF and wait at least 30 seconds.
-
Ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “MULTI AV”.
-
Check DTC.
Is DTC B1341 detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
DETERMINE MALFUNCTION TYPE
CONSULT
-
Ignition switch ON.
-
Ignition switch OFF and wait at least 30 seconds.
-
Ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “MULTI AV”.
-
Check DTC.
Is DTC B1341–16, 17, 49, 55 or 98 detected?
YES>>16 [VB–LOW], or 17 [VB–HIGH] – GO TO 2.
YES>>49 [—] – GO TO 4.
YES>>55 [CONFIG] – GO TO 3.
YES>>98 [TEMP] – GO TO 5.
NO>>Refer to Intermittent Incident.
CHECK BATTERY VOLTAGE
Check 12volt battery voltage.
Is 12volt battery voltage less than 8.8V?
YES>>Charge battery and retest. Refer to Work Flow (With 165-DSS-5000P), or (Without 165-DSS-5000P).
NO>>Replace audio unit. Refer to Removal and Installation.
PERFORM CONFIGURATION PROCEDURE
Perform configuration of audio unit. Refer to Work Procedure.
>>
GO TO 4.
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
CONSULT
-
Ignition switch ON.
-
Erase DTC.
-
Perform DTC confirmation procedure again. Refer to Confirmation Procedure.
Is DTC B1341–49 or B1341–55 detected again?
YES>>Replace audio unit. Refer to Removal and Installation.
NO>>Inspection End.
CHECK AUDIO UNIT
Visually check around audio unit for a cause of high temperature.
Is the inspection result normal?
YES>>GO TO 6.
NO>>Remove cause of high temperature.
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Ignition switch OFF and wait at least 30 seconds.
-
Ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “MULTI AV”.
-
Check DTC.
Is DTC B1341–98 detected?
YES>>Replace audio unit. Refer to Removal and Installation.
NO>>Inspection End.
B1339 Rear Camera Connection
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B1339-8F
Rear camera connection
(Rear view camera connection)
[–]
Diagnosis condition
When ignition switch is ON...
B1360 Combination Meter
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B1360–02
Combination meter
(Combination meter connection error)
Diagnosis condition
When ignition switch is ON...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Additional Service When Removing Battery Negative Terminal
Description When the negative battery terminal is disconnected, the initialization is necessary for normal operation of power window system.CAUTION: The following specified operations can not be performed under the non-initialized condition: Auto-up operation Anti-pinch function Work Procedure SYSTEM INITIALIZATION Perform system initialization...
Nissan Murano (Z52) 2015-2024 Service Manual: Control Valve
Exploded View 1. Transaxle assembly 2. Terminal cord assembly 3. Control valve 4. Bracket 5. O-ring 6. Oil strainer assembly 7. Oil pan gasket 8. Oil pan 9. Drain plug 10. Drain plug gasket 11. Magnet 12...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- All-Wheel Drive (AWD) (if so equipped)
- How to enable/disable the LDW system
- Warning lights
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
