Nissan Murano: Door & Lock :: Symptom Diagnosis / Automatic Back Door Functions Do Not Cancel
REPLACE AUTOMATIC BACK DOOR CONTROL MODULE
-
Replace automatic back door control module. Refer to Removal and Installation.
-
Confirm the operation after replacement.
Is the result normal?
YES>>Inspection End.
NO>>Check intermittent incident. Refer to Intermittent Incident.
Automatic Back Door Warning Does Not Operate. Buzzer
Diagnosis Procedure
Automatic back door warning buzzer does not operate when automatic back door warning function is performed.CHECK DTC WITH AUTOMATIC BACK DOOR CONTROL MODULE
Check that DTC is not detected with automatic back door control module...
Automatic Back Door Anti-Pinch Function Does Not Operate
Diagnosis Procedure
CHECK POWER SUPPLY AND GROUND CIRCUIT
Check automatic back door control module power supply and ground circuit.
Refer to Diagnosis Procedure...
Other information:
Nissan Murano (Z52) 2015-2024 Owners Manual: System maintenance
The sensor is located on the front of the vehicle. To keep the system operating properly, be sure to observe the following: Always keep the sensor area of the front bumper clean. Do not strike or damage the areas around the sensor. Do not cover or attach stickers or similar objects on the front bumper near the sensor area...
Nissan Murano (Z52) 2015-2024 Service Manual: Diagnosis and Repair Workflow
Work Flow OVERALL SEQUENCEDETAILED FLOWINTERVIEW CUSTOMER Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred. >> GO TO 2. REPRODUCE THE MALFUNCTION Reproduce the malfunction on the Nissan Murano vehicle that the customer describes...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Memory storage function (key-link)
- GAS STATION INFORMATION
- Turning the AEB system on/off
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
