Nissan Murano: Engine Mechanical :: Periodic Maintenance / Air Cleaner Filter
| 1. | Air duct hose and resonator assembly | 2. | Front air duct | 3. | Grommet |
| 4. | Air cleaner case (lower) | 5. | Grommets | 6. | Air cleaner case mounting bracket |
| 7. | Bracket | 8. | Air cleaner filter | 9. | Air cleaner case (upper) |
| 10. | Mass air flow sensor | A. | Air cleaner case side clips | B. | To electric throttle control actuator. Refer to Exploded View. |
 |
Front |
REMOVAL
CAUTION:
It is not necessary to remove the front air duct to replace the air cleaner filter.
NOTE:
Replace the air cleaner filter per the periodic maintenance schedule or as necessary. Refer to Introduction of Periodic Maintenance.
Unhook air cleaner case side clips and lift air cleaner case (upper).
Remove the air cleaner filter.
INSTALLATION
Installation is in the reverse order of removal.
Drive Belt
Exploded View
1.
Drive belt auto-tensioner
2.
Generator
3.
A/C compressor
4.
Drive belt
5.
Crankshaft pulley
A.
Indicator
B...
Spark Plug
Exploded View
1.
Ignition coil
2.
Spark plug
3.
Rocker cover (RH)
4.
Rocker cover (LH)
Front
Removal and Installation
REMOVALRemove the ignition coil...
Other information:
Nissan Murano (Z52) 2015-2024 Owners Manual: Unfastening the seat belts. Checking seat belt operation
Unfastening the seat belts To unfasten the seat belt, press the button on the buckle . The seat belt automatically retracts. Checking seat belt operation Seat belt retractors are designed to lock seat belt movement by two separate methods: When the seat belt is pulled quickly from the retractor When the vehicle slows down rapidly To increase your confidence in the seat belts, check the operation as follows: Grasp the shoulder belt and pull forward quickly...
Nissan Murano (Z52) 2015-2024 Service Manual: C1205 4wd Actuator Relay
DTC Description DTC DETECTION LOGICMalfunction has been detected from AWD actuator relay integrated with AWD control unit, or malfunction related to AWD solenoid has been detected. DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition C1205 4WD ACTUATOR RLY (4WD actuator relay) Diagnosis condition Ignition switch: ON Signal — Threshold — Diagnosis delay time — POSSIBLE CAUSE Internal malfunction of AWD control unit Malfunction of AWD solenoid power supply circuit (ground short) FAIL-SAFEFront-wheel drive or shifts to 4-wheel drive (rear-wheels still have some driving torque)...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- GAS STATION INFORMATION
- Rear bench seat adjustment
- All-Wheel Drive (AWD) (if so equipped)
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
