Nissan Murano: Engine Mechanical :: Periodic Maintenance / Spark Plug
| 1. | Ignition coil | 2. | Spark plug | 3. | Rocker cover (RH) |
| 4. | Rocker cover (LH) |  |
Front |
REMOVAL
Remove the ignition coil. Refer to Removal and Installation (bank 2) and Removal and Installation (bank 1).
Remove the spark plug with Tool.
| Tool number | : — (J-48891) |
INSPECTION AFTER REMOVAL
Use the standard type spark plug for normal condition.
| Spark plug | : Refer to Spark Plug. |
CAUTION:
-
Do not drop or shock spark plug. Discard spark plug if dropped.
-
Do not use a wire brush for cleaning.
-
If plug is covered with carbon, a spark plug cleaner may be used.
| Cleaner air pressure | : less than 588 kPa (6 kg/cm2, 85 psi) |
| Cleaning time | : less than 20 seconds |
-
Spark plug gap adjustment is not required between replacement intervals.
-
Measure spark plug gap. When it exceeds the limit, replace spark plug even if it is within the specified replacement mileage. Refer to Spark Plug.
INSTALLATION
Installation is in the reverse order of removal.
| Make | DENSO |
| Standard type* | FXE22HR11 |
| Gap (nominal) | 1.1 mm (0.043 in) |
*: Always check with the Parts Department for the latest parts information.
Air Cleaner Filter
Exploded View
1.
Air duct hose and resonator assembly
2.
Front air duct
3.
Grommet
4.
Air cleaner case (lower)
5.
Grommets
6.
Air cleaner case mounting bracket
7...
Camshaft Valve Clearance
Valve Clearance
CHECKINGCAUTION:
Check valve clearance while engine is cold and not running.
NOTE:
Perform valve clearance inspection after removal, installation or replacement of camshaft or valve parts, or as necessary...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Front Wiper and Washer System
System Description SYSTEM DIAGRAMSignal transmission function list Signal name Input Output Description Combination switch signal Combination switch (wiper and washer switch) BCM Transmits the combination switch signal to the BCM. Nissan Murano Vehicle speed signal Combination meter BCM (CAN) Transmits the vehicle speed signal via CAN communication...
Nissan Murano (Z52) 2015-2024 Service Manual: B2556 Push-Btn Ign Sw
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition B2556 PUSH-BTN IGN SW (Push-button ignition switch) Diagnosis condition When ignition switch ON. Signal (terminal) — Threshold BCM detects the ignition switch stuck at ON for 100 seconds or more Diagnosis delay time — POSSIBLE CAUSE Push-button ignition switch BCM Harness or connector (Ignition switch circuit is shorted...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Vehicle Dynamic Control (VDC) OFF switch
- Shift lock release
- Fuel recommendation
- New on site
- Most important about car
Autolight system
The autolight system allows the headlights to turn on and off automatically. The autolight system can:
Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark. Turn off all the lights (except daylight running lights) when it is light. Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.