Nissan Murano: Heater & Air Conditioning Control System :: Basic Inspection / Additional Service When Replacing Control Unit (a/c Auto Amp.)
When replacing A/C auto amp., save or print current vehicle specification with CONSULT “Configuration” before replacement.
BEFORE REPLACEMENT
NOTE:
If “READ CONFIGURATION” can not be used, use the “MANUAL CONFIGURATION” after replacing A/C auto amp.
AFTER REPLACEMENT
CAUTION:
-
When replacing A/C auto amp., you must perform “WRITE CONFIGURATION” with CONSULT.
-
Never perform “WRITE CONFIGURATION” except for new A/C auto amp.
SAVING VEHICLE SPECIFICATION
CONSULT
Perform “READ CONFIGURATION” to save or print current Nissan Murano vehicle specification. Refer to Description.
NOTE:
If “READ CONFIGURATION” can not be used, use “MANUAL CONFIGURATION” after replacing A/C auto amp.
>>
GO TO 2.
REPLACE A/C AUTO AMP.
Replace A/C auto amp. Refer to Removal and Installation.
>>
GO TO 3.
WRITING Nissan Murano Vehicle SPECIFICATION
CONSULT
Perform “WRITE CONFIGURATION - Config file” or “MANUAL CONFIGURATION” to write Nissan Murano vehicle specification. Refer to Work Procedure.
>>
Work End.
Operation Inspection
Work Procedure
DESCRIPTIONThe purpose of the operational check is to check that the individual system operates normally. Check condition
: Engine running at normal operating temperature...
Configuration (hvac)
Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing A/C auto amp.Configuration has three functions as follows: Function Description
READ CONFIGURATION
Reads the Nissan Murano vehicle configuration of current A/C auto amp...
Other information:
Nissan Murano (Z52) 2015-2024 Owners Manual: Cleaning
If your windshield is not clear after using the windshield-washer or if a wiper blade chatters when running, wax or other material may be on the blade or windshield. Clean the outside of the windshield with a washer solution or a mild detergent. Your windshield is clean if beads do not form when rinsing with clear water...
Nissan Murano (Z52) 2015-2024 Service Manual: Door Does Not Lock/unlock and Engine Does Not Start (req Sw/push Sw) (one Key)
Diagnosis Procedure Door does not lock/unlock with door request switch, and engine does not start when ignition switch is pressed while carrying Intelligent Key. (One Intelligent Key has the symptom, other keys operate normally.)SYMPTOM TABLE (ONE INTELLIGENT KEY HAS THE SYMPTOM, OTHER KEYS OPERATE NORMALLY) Door lock operation (remote keyless entry) Door lock operation (request switch) or back door open operation (opener switch of back door panel) Engine started with push-button ignition switch operation (Intelligent Key is within the detection area of inside key antenna) Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) OK NG No crank, No start OK DIAGNOSIS PROCEDURERefer to Diagnosis Procedure...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Checking engine oil level
- Power Steering Fluid (PSF)
- Warning lights
- New on site
- Most important about car
Vehicle security system
Your vehicle has two types of security systems:
Vehicle security system NISSAN Vehicle Immobilizer SystemThe vehicle security system provides visual and audible alarm signals if someone opens the doors, liftgate or the hood when the system is armed. It is not, however, a motion detection type system that activates when a vehicle is moved or when a vibration occurs.
