Nissan Murano: Door & Lock :: Basic Inspection / Additional Service When Replacing Bcm

Additional Service When Removing Battery Negative Terminal

Description When the battery is disconnected from the negative terminal, it is necessary to perform initial setting to operate automatic back door control system normally...

Calibration of Automatic Back Door Position Information

Description When the following work is performed, it is necessary to perform initial setting of automatic back door position information to operate automatic back door system: After removing and installing or replacing back door assembly After removing and installing or replacing spindle unit After adjustment or position change of the back door hinges or striker Work Procedure STEP 1 Fully close the back door manually...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Transfer Cover

Exploded View Oil seal Transfer cover Filler plug Gasket Drain plug Oil seal O-ring Ring gear bearing adjusting shim (transfer cover side) Ring gear bearing (transfer cover side) Drive shaft oil seal Ring gear shaft Ring gear bearing (transfer case side) Ring gear bearing adjusting shim (transfer case side) Ring gear Baffle plate Transfer case Plug O-ring Oil seal Dowel pin Drive pinion Drive pinion adjusting shim O-ring Pinion bearing assembly Oil seal Dust cover Companion flange Pinion lock nut         Oil seal lip Comply with the assembly procedure when tightening...

Nissan Murano (Z52) 2015-2024 Service Manual: P0607 Ecm

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0607 ECM (Control module performance) Diagnosis condition Ignition switch ON Signal (terminal) — Threshold ECM internal communication system is malfunctioning Diagnosis delay time — POSSIBLE CAUSE ECM FAIL-SAFE Engine operating condition in fail-safe mode Fail safe mode Nissan Murano Vehicle behavior ECM Engine torque may be limited...