Nissan Murano: Door & Lock :: Basic Inspection / Additional Service When Removing Battery Negative Terminal
When the battery is disconnected from the negative terminal, it is necessary to perform initial setting to operate automatic back door control system normally.
NOTE:
The following specified operations are not performed under the non-initialized condition:
-
Automatic back door open/close function
-
Anti-pinch function
INITIALIZATION
-
Fully close the back door manually. (When back door is already fully closed, this operation is not necessary.)
-
Perform automatic back door open/close operation of back door.
-
Check for noise or malfunctioning during operation.
-
Check that warning buzzer operates.
NOTE:
Never touch back door or allow foreign materials to be pinched in door when performing automatic back door open/close operation until it is in the fully closed or fully open position.
>>
Inspection End.
Diagnosis and Repair Work Flow
Work Flow
OVERALL SEQUENCEDETAILED FLOWGET INFORMATION FOR SYMPTOM
Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurs)...
Additional Service When Replacing Bcm
Description
CAUTION:
When replacing the BCM, a new BCM must be used. The functions controlled by the BCM do not operate properly if a BCM from another Nissan Murano vehicle is used...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Structure and Operation
Sectional View Transfer cover Transfer case Ring gear bearing (transfer case side) Ring gear shaft Pinion bearing Drive pinion Companion flange Ring gear Ring gear bearing (transfer cover side) Operation Description POWER TRANSFER DIAGRAMELECTRIC CONTROLLED COUPLING The AWD control unit supplies command current to electric controlled coupling (AWD solenoid)...
Nissan Murano (Z52) 2015-2024 Service Manual: P0112 Iat Sensor
DTC Description DTC DETECTION LOGIC An excessively low voltage from the sensor is sent to ECM. An excessively high voltage from the sensor is sent to ECM. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0112 IAT SEN/CIRCUIT-B1 (Intake air temperature sensor 1 circuit low bank 1) Diagnosis condition Ignition switch ON Signal (terminal) Voltage signal transmitted from intake air temperature sensor to ECM Threshold An excessively low voltage from the sensor is sent to ECM Diagnosis delay time — P0113 IAT SEN/CIRCUIT-B1 (Intake air temperature sensor 1 circuit high bank 1) Diagnosis condition Ignition switch ON Signal (terminal) Voltage signal transmitted from intake air temperature sensor to ECM Threshold An excessively high voltage from the sensor is sent to ECM Diagnosis delay time — POSSIBLE CAUSEP0112 Harness and connectors (The sensor circuit is open or shorted...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Warning lights
- GAS STATION INFORMATION
- How to enable/disable the LDW system
- New on site
- Most important about car
Vehicle security system
Your vehicle has two types of security systems:
Vehicle security system NISSAN Vehicle Immobilizer SystemThe vehicle security system provides visual and audible alarm signals if someone opens the doors, liftgate or the hood when the system is armed. It is not, however, a motion detection type system that activates when a vehicle is moved or when a vibration occurs.
