Nissan Murano: Dtc/circuit Diagnosis / A-Bag Branch Line Circuit

Nissan Murano (Z52) 2015-2024 Service Manual / Electrical & Power Control / Lan System :: Can / Dtc/circuit Diagnosis / A-Bag Branch Line Circuit

Diagnosis Procedure

WARNING:

  • Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait 3 minutes or more. (To discharge backup capacitor.)

  • Never use unspecified tester or other measuring device.

CHECK CONNECTOR

  1. Turn the ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Check the terminals and connectors of the air bag diagnosis sensor unit for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Replace the main harness.

CHECK AIR BAG DIAGNOSIS SENSOR UNIT

Check the air bag diagnosis sensor unit. Refer to Work Flow.

Is the inspection result normal?

YES>>

Replace the main harness.

NO>>

Replace parts whose air bag system has a malfunction.

    Tcu Branch Line Circuit

    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side)...

    Dlc Branch Line Circuit

    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side)...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: P0116 Ect Sensor


    DTC Description DTC DETECTION LOGICThe comparison result of signals transmitted to ECM from each temperature sensor (IAT sensor, ECT sensor, FTT sensor, and EOT sensor) shows that the voltage signal of the ECT sensor is higher/lower than that of other temperature sensors when the engine is started with its cold state...

    Nissan Murano (Z52) 2015-2024 Owners Manual: RAB system limitations


    WARNING Listed below are the system limitations for the RAB system. Failure to follow the warnings and instructions for proper use of the RAB system could result in serious injury or death. When the vehicle approaches an obstacle while the accelerator or brake pedal is depressed, the function may not operate or the start of operation may be delayed...

    Categories

    LATCH (Lower Anchors and Tethers for CHildren) system

    Nissan Murano. LATCH (Lower Anchors and Tethers for CHildren) system

    LATCH system lower anchor locations - bench seat

    Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.

    read more

     
    Copyright © 2026 www.nimurano.com