Nissan Murano: Driver Controls / Wiper & Washer :: Preparation. Preparation
|
Tool number (TechMate No.) Tool name | Description | |
|---|---|---|
|
— (J-46534) Trim Tool Set |
|
Removing trim components |
Wiper & Washer :: Precaution. Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: P0454 Evap Control System Pressure Sensor
DTC Description DTC DETECTION LOGICECM detects a sloshing signal from the EVAP control system pressure sensor. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0454 EVAP SYS PRES SEN (Evaporative emission system pressure sensor/switch range/performance) Diagnosis condition — Signal (terminal) Voltage signal transmitted from EVAP control system pressure sensor to ECM Threshold ECM detects a sloshing signal from the EVAP control system pressure sensor Diagnosis delay time — POSSIBLE CAUSE Harness or connectors (EVAP control system pressure sensor circuit is shorted...
Nissan Murano (Z52) 2015-2024 Service Manual: Heated Steering Wheel System
Component Function Check CHECK HEATED STEERING WHEEL SYSTEM Check operation of heated steering wheel system. Refer to System Description. Is the inspection result normal? YES>> Inspection End. NO>> Refer to Diagnosis Procedure. Diagnosis Procedure CHECK POWER CIRCUIT Ignition switch OFF...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Power Steering Fluid (PSF)
- Shift lock release
- GAS STATION INFORMATION
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
