Nissan Murano: Driver Controls / Wiper & Washer :: Basic Inspection. Diagnosis and Repair Workflow
OVERALL SEQUENCE
DETAILED FLOW
INTERVIEW CUSTOMER
Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred.
>>
GO TO 2.
REPRODUCE THE MALFUNCTION
Reproduce the malfunction on the Nissan Murano vehicle that the customer describes.
Inspect the relation of the symptoms and the condition when the symptoms occur.
>>
GO TO 3.
SYMPTOM DIAGNOSIS
Use Symptom diagnosis from the symptom inspection result in step 2 and then identify where to start performing the diagnosis based on possible causes and symptoms.
>>
GO TO 4.
COMPONENT DIAGNOSIS
Perform the diagnosis with Component diagnosis of the applicable system.
>>
GO TO 5.
REPAIR OR REPLACE MALFUNCTIONING PART
Repair or replace the specified malfunctioning parts.
>>
GO TO 6.
PERFORM FINAL OPERATION CHECK
Check that malfunctions are not reproduced when obtaining the malfunction information from the customer, referring to the symptom inspection result in step 2.
Are the malfunctions corrected?
YES>>Inspection End.
NO>>GO TO 3.
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Exterior :: Symptom Diagnosis. Squeak and Rattle Trouble Diagnoses
Work Flow CUSTOMER INTERVIEWInterview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any customer's comments; refer to Diagnostic Worksheet...
Nissan Murano (Z52) 2015-2024 Service Manual: P2610 Ecm Internal Timer
DTC Description DESCRIPTIONThis ECM contains a timer and measures time between an ignition switch OFF and the next ignition switch ON. This enables the judging of the state of engine cooling at an engine start.DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2610 ECM/PCM INTERNAL ENG OFF TIMER (ECM/PCM internal engine off timer performance) 1 Diagnosis condition — Signal (terminal) — Threshold ECM internal engine off timer is malfunctioning Diagnosis delay time — 2 Diagnosis condition — Signal (terminal) — Threshold The time calculated by ECM based on a descent allowance of engine coolant temperatures during ignition switch OFF is extremely shorter than the time counted by the Engine internal OFF timer Diagnosis delay time — POSSIBLE CAUSE ECM ECM power supply FAIL-SAFENot applicable DTC Confirmation Procedure INSPECTION START It is necessary to erase permanent DTC? YES>> GO TO 4...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Passenger compartment
- Rear bench seat adjustment
- Fuel recommendation
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
