Nissan Murano: Rear Lh Side Power Window Alone Does Not Operate / When Main Power Window and Door Lock/unlock Switch Is Operated
Diagnosis Procedure
CHECK REAR POWER WINDOW SWITCH LH SERIAL LINK CIRCUIT
Check rear power window switch LH serial link circuit.
Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CONFIRM THE OPERATION
Confirm the operation again.
Is the inspection result normal?
YES>>
Check intermittent incident. Refer to Intermittent Incident.
NO>>
GO TO 1.
Diagnosis Procedure
REPLACE REAR POWER WINDOW SWITCH LH
Replace rear power window switch LH.
Refer to Removal and Installation.
>>
Inspection End...
Other information:
Diagnosis Procedure
All doors do not lock/unlock using door request switch or back door does not open using back door opener request switch, Intelligent Key, and engine does not start when ignition switch is pressed while carrying Intelligent Key.SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) Door lock operation (remote keyless entry) Door lock operation (request switch) or back door open operation (opener switch of back door panel) Engine started with ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) Engine started with ignition switch operation (registered Intelligent Key placed next to ignition switch)
NG
NG
No crank, No start
OK
CONDITIONS OF VEHICLE (OPERATING CONDITIONS)“ENGINE START BY I-KEY” setting in “Work support” mode of “BCM(INTELLIGENT KEY)” is ON...
If, because of body size or driving position, it
is not possible to properly fit the
lap/shoulder belt and fasten it, an extender
that is compatible with the installed seat
belts is available for purchase. The extender
adds approximately 8 in (200 mm)
of length and is available for the:
Driver and front passenger seating positions
It is recommended that you visit a NISSAN
dealer for assistance with purchasing an
extender if an extender is required...