Nissan Murano: Dtc/circuit Diagnosis / U1300 Av Comm Circuit
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| U1300–01 |
AV communication circuit (AV communication circuit) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | — | ||
| Threshold | — | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
-
AV communication circuit
-
AV control unit
-
Combination meter
FAIL-SAFE
AV communication is inoperative
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Ignition switch OFF and wait at least 30 seconds.
-
Ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “MULTI AV”.
-
Check DTC.
Is DTC U1300 detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
CHECK SELF DIAGNOSTIC RESULT
Check if any DTC other than “U1300” is detected in “Self diagnostic result” of “MULTI AV”.
Is any DTC detected?
YES>>Perform diagnosis on the detected DTC and repair or replace the malfunctioning parts. Refer to DTC Index.
NO>>Replace AV control unit. Refer to Removal and Installation.
U1000 Can Comm Circuit
DTC Description
DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real-time application. It is an on-Nissan Murano vehicle multiplex communication line with high data communication speed and excellent error detection ability...
Power Supply and Ground Circuit. Av Control Unit
Diagnosis Procedure
CHECK FUSE
Check that the following fuses are not blown:
Terminal No. Signal name Fuse No. Capacity
7
ACC power supply
7
10 A
17
Ignition power supply
29
10 A
19
Battery power supply
15
20 A
Are the fuses blown?
YES>>
Replace the blown fuse after repairing the affected circuit...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Low Tire Pressure Warning Lamp Blinks
Diagnosis Procedure When the ignition switch is placed ON, the low tire pressure warning lamp blinks. And then 1 minute later, low tire pressure warning lamp turns ON.NOTE: The position of an inactive tire pressure sensor can be identified by checking the blinking timing of the low tire pressure warning lamp...
Nissan Murano (Z52) 2015-2024 Service Manual: Transaxle Assembly
Exploded View Transaxle assembly Terminal cord assembly Control valve Bracket O-ring Oil strainer assembly Oil pan gasket Oil pan Drain plug Drain plug gasket Magnet Spring washer Manual plate Lip seal Snap ring Overflow plug O-ring : Always replace after every disassembly : N·m (kg-m, ft-lb) : N·m (kg-m, in-lb) : Apply CVT fluid : Apply petroleum jelly Reduction gear assembly Differential assembly Clip Lubrication tube Baffle plate Converter housing Baffle plate Snap ring Drive sprocket Driven sprocket Oil pump chain O-ring Baffle plate (Chain cover) Thrust bearing Thrust bearing race Dummy cover Thrust washer Chain guide Bracket Oil pump O-ring Transaxle case : Always replace after every disassembly...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Vehicle Dynamic Control (VDC) OFF switch
- Memory storage function (key-link)
- Passenger compartment
- New on site
- Most important about car
Autolight system
The autolight system allows the headlights to turn on and off automatically. The autolight system can:
Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark. Turn off all the lights (except daylight running lights) when it is light. Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.