Nissan Murano: Dtc/circuit Diagnosis / U0122 Lost Communication (vdc)
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | |
| U0122 |
LOST COMM (BRAKE C/U) (Lost Communication With Nissan Murano Vehicle Dynamics Control Module) |
Diagnosis condition | When the ignition switch is ON |
| Signal | CAN communication signal | ||
| Threshold | TCM is unable to receive the CAN communications signal from ABS actuator and electric unit (control unit) | ||
| Diagnosis delay time | Continuously for 2 seconds or more | ||
POSSIBLE CAUSE
-
ABS actuator and electric unit (control unit)
-
Harness or connector (CAN communication line is open or shorted)
FAIL-SAFE
Not changed from normal driving
DTC CONFIRMATION PROCEDURE
CHECK DTC PRIORITY
WhenDTC U0122 is displayed together with DTC U0300, diagnose first the DTC U0300.
Is "U0300" detected?
YES>>Perform diagnosis of DTC U0300. Refer to Diagnosis Procedure.
NO>>GO TO 2.
PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>>
GO TO 3.
PERFORM DTC CONFIRMATION PROCEDURE
-
Ignition switch ON and wait for at least 2 seconds.
-
Check the DTC.
Is DTC detected?
YES>>Proceed to Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: INSPECTION END
For the diagnosis procedure, refer to Trouble Diagnosis Flow Chart.
U0102 Lost Communication (transfer)
DTC Description
DTC DETECTION LOGICWhen the ignition switch is ON, TCM is unable to receive the CAN communications signal from AWD control unit continuously for 2 seconds or more...
U0300 Can Communication Data
DTC Description
DTC DETECTION LOGICWhen the ignition switch is ON, the data length transmitted from each control unit is shorter than the specified length and the status continues for 2 seconds or more...
Other information:
Nissan Murano (Z52) 2015-2024 Owners Manual: System maintenance
The sensor for the ICC system is located on the front of the vehicle. To keep the ICC system operating properly, be sure to observe the following: Always keep the sensor area clean. Do not strike or damage the areas around the sensor. Do not attach a sticker (including transparent material) or install an accessory near the sensor...
Nissan Murano (Z52) 2015-2024 Service Manual: Instrument Panel :: Preparation. Preparation
Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description — (J-39570) Chassis Ear Locating the noise — (J-50397) Squeak and Rattle Kit Repairing the cause of noise — (J-46534) Trim Tool Set Removing trim components Commercial Service Tools (TechMate No...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Shift lock release
- Memory storage function (key-link)
- All-Wheel Drive (AWD) (if so equipped)
- New on site
- Most important about car
Fuel gauge
The gauge indicates the approximate fuel level in the tank.
The gauge may move slightly during braking, turning, acceleration, or going up or down hills.
The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.
