Nissan Murano: Rear Automatic Braking (RAB) (if so equipped) / Turning the RAB system on/off
Perform the following steps to turn the RAB
system on or off.
- Press the
button until
“Settings”
displays in the vehicle information display
and then press the OK button. Use
the
button to select “Driver
Assistance.”
Then press the OK button.
- Select “Emergency Brake” and press
the OK button.
- To set the RAB system to on or off, use
the OK button to check the box for
“Rear.”
When the RAB system is turned off, the RAB
system warning light illuminates.
NOTE:
The RAB system will be automatically
turned on when the engine is restarted.
RAB system warning light and
RAB system
warning indicator
Steering-wheel-mounted controls (left
side)
Center display (if so equipped)
When the shift lever is in the R (Reverse)
position and the vehicle speed is less than
approximately 9 mph (15 km/h), the RAB
system operates...
WARNING
Listed below are the system limitations
for the RAB system. Failure to follow the
warnings and instructions for proper
use of the RAB system could result in
serious injury or death...
Other information:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...
Abbreviations: I = Inspect and correct or replace as necessary, R =
Replace
NOTE:
(1) After 40,000 miles (64,000 km) or 48 months, inspect every 10,000
miles (16,000 km) or 12 months. Replace the drive belt if
found damaged.
(2) If operating mainly in dusty conditions, more frequent maintenance
may be required...