Nissan Murano: Basic Inspection / Stall Test
INSPECTION
Check the engine oil level. Replenish if necessary. Refer to Inspection.
Check for leak of the CVT fluid. Refer to Inspection.
Drive for about 10 minutes to warm up the Nissan Murano vehicle so that the CVT fluid temperature is 50 to 80°C (122 to 176°F).
Be sure to apply the parking brake and block the tires.
Start the engine, depress the brake pedal and put the selector lever to the D position.
While depressing the brake pedal, depress the accelerator pedal gradually.
Read the stall speed quickly. Then, release your foot from the accelerator pedal quickly.
CAUTION:
Do not depress the accelerator pedal for 5 seconds or more during the test.
| Stall speed | : Refer to Stall Speed. |
Place the selector lever in the N position.
Cool the CVT fluid.
CAUTION:
Run the engine with the idle speed for at least 1 minute.
Put the selector lever to the R position and perform Step 6 to Step 9 again.
NARROWING-DOWN MALFUNCTIONING PARTS
| Selector lever position | Possible cause | ||
| D | R | ||
| Stall speed | H | O |
|
| O | H |
|
|
| L | L |
|
|
| H | H |
|
|
O: Within the stall speed standard value.
H: Stall speed is higher than the standard value.
L: Stall speed is lower than the standard value.
Cvt Fluid Cooler System
Exploded View
Transaxle assembly
Hose clamp
CVT fluid cooler hose A
Hose clip
CVT fluid cooler hose B
Connector tube
CVT fluid cooler hose C
Oil warmer
To radiator...
Cvt Position
Inspection and Adjustment
INSPECTIONTurn ON the ignition switch with the shift selector at the “P” position.
Press the shift selector button with the brake pedal depressed, and confirm that the shift selector can be moved to positions other than “P”...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: P1614 Chain of Immu-Key
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition P1614 CHAIN OF IMMU-KEY (Chain of immobilizer-key) Diagnosis condition When ignition switch ON. Signal (terminal) — Threshold Inactive communication between NATS antenna amp...
Nissan Murano (Z52) 2015-2024 Service Manual: P2814 Select Solenoid
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2814 SELECT SOLENOID (Select solenoid) Diagnosis condition TCM power supply voltage: 11 V or more Signal — Threshold TCM judges that solenoid valve circuit is shorted to ground Diagnosis delay time Maintained for 1 second POSSIBLE CAUSE Harness or connector (Select solenoid valve circuit shorted to ground) Select solenoid valve FAIL-SAFESelector shock is large DTC Confirmation Procedure CAUTION: Be careful of the driving speed...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- System malfunction
- How to enable/disable the LDW system
- Fuel recommendation
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
